How to change the IP Address on a 1net1 R-90 router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

This page shows how to change the LAN IP Address on the 1net1 R-90 router.

Other 1net1 R-90 Guides

This is the ip address guide for the 1net1 R-90. We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

  • 192.168.0.1
  • 192.168.1.1
  • 10.0.0.1

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The 1net1 R-90

To get started configuring the 1net1 R-90 LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the 1net1 R-90, follow our 1net1 R-90 Login Guide.

Change the LAN IP Address on a 1net1 R-90

If you followed our login guide above then you should see this screen.

router status mac address internet IP
This is the status page from your 1net1 R-90 router.

On the 1net1 R-90 when you first log in you should see the Router Status screen. This screen says Mobile Broadband Gateway R-90 at the top in a yellow bar. To change the IP Address on the 1net1 R-90 you start by clicking on LAN IP Setup in the left column.

Configure the LAN section of your 1net1 R-90

router setup
This is the setup page from your 1net1 R-90 router.

In the box labeled IP Address type in the new IP Address that you have chosen for your router. Leave the Subnet Mask set to 255.255.255.0, which should be the default. You can also leave the DHCP settings alone, the 1net1 R-90 will pick them for you.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other 1net1 R-90 Info

Don't forget about our other 1net1 R-90 info that you might be interested in.

This is the ip address guide for the 1net1 R-90. We also have the following guides for the same router: