Setup Router logo in white Setup router name logo in white
Get Software

ACorp Sprinter LAN420M Default Password

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

To login to the ACorp Sprinter-LAN420M interface section you probably need to know the default username and password.

This password and username are not the same as a Internet username and password if you use one. The router username and password will only access the router's setup pages.

Other ACorp Sprinter LAN420M Guides

This is the password guide for the ACorp Sprinter LAN420M. We also have the following guides for the same router:

Default Password for the ACorp Sprinter LAN420M

In the table below we have found all the known usernames and passwords this ACorp Sprinter-LAN420M router uses. Go ahead and give these a try first in order to login to the router setup.

admin admin

If that table didn't work it is possible you have a different firmware version of this router. Router manufacturers are always creating new firmware versions in an attempt to keep up with technology. Sometimes these new updates contain a new username and password. If this is the case for your router you can try our more broad list of all known ACorp passwords.

Default IP Address for the ACorp Sprinter LAN420M

When you access your ACorp Sprinter-LAN420M router setup you will also need to know it's default IP address. You type this in the address bar at the top of a web page. This is how your computer knows where to find your router on your network. Below is the list of all known ACorp Sprinter-LAN420M default IP addresses. Try using these to login to your router.

192.168.1.1

Note: If the above items didn't work it's possible someone changed this IP address in the past. If the list above didn't work then try our free Router Detector software. It will isolate your router's IP address and let you know what it is.

ACorp Sprinter LAN420M Password Does Not Work

There's lots of different reasons why the default password didn't work for your ACorp Sprinter-LAN420M router. Most likely someone in the past changed it.

If you have tried all the above combos and still are unable to connect to your ACorp Sprinter-LAN420M router's interface then you need to reset your router to it's original factory defaults. Use our How to Reset the ACorp Sprinter-LAN420M guide.

Make sure you heed the warnings at the top of that guide. Resetting the router can cause you to lose Internet connection if you don't know your ISP username and password.

ACorp Sprinter LAN420M Help

Be sure to check out our other ACorp Sprinter LAN420M info that you might be interested in.

This is the password guide for the ACorp Sprinter LAN420M. We also have the following guides for the same router: