How to change the IP Address on a Actiontec Q1000 Qwest router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

This page shows how to change the LAN IP Address on the Actiontec Q1000 Qwest router.

Other Actiontec Q1000 Qwest Guides

This is the ip address guide for the Actiontec Q1000 Qwest. We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

  • 192.168.0.1
  • 192.168.1.1
  • 10.0.0.1

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Actiontec Q1000 Qwest

To get started configuring the Actiontec Q1000 Qwest LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Actiontec Q1000 Qwest, follow our Actiontec Q1000 Qwest Login Guide.

Change the LAN IP Address on a Actiontec Q1000 Qwest

If you followed our login guide above then you should see this screen.

router status mac address internet IP
This is the status page from your Actiontec Q1000 Qwest router.

Now that you are on the Homepage of the Actiontec Q1000 - Qwest you see five choices. Choose the one labeled Advanced Setup in red.

Next choose LAN IP Address under the file name IP Addressing on the left of the screen.

Configure the LAN section of your Actiontec Q1000 Qwest

router setup
This is the setup page from your Actiontec Q1000 Qwest router.

Then click the box labeled Modem IP Address, this is where you enter your new IP Address. We recommend the address of 192.168.0.1

Make sure the Modem Subnet Mask remains as 255.255.255.0

Don't forget to click Apply and Reboot.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other Actiontec Q1000 Qwest Info

Don't forget about our other Actiontec Q1000 Qwest info that you might be interested in.

This is the ip address guide for the Actiontec Q1000 Qwest. We also have the following guides for the same router: