Setup Router logo in white Setup router name logo in white
Get Software

How to Reset the Actiontec V1000H

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 4 minutes

In this guide we will go over how to reset the Actiontec V1000H Telus router. When you reset the router it reverts to factory settings. This is different than rebooting the router which consists of only turning it off and back on again to cycle the power.

Warning: Resetting your router is serious and should not be taken lightly. Only proceed with this reset if you have considered the following:

  • The router's main username and password are reset to factory settings.
  • The Internet username and password are reset.
  • If you use a DSL router, a ISP username and password will be required to continue using your Internet. If you are unsure call your Internet Service Provider.
  • All configurations you have made are erased. This includes firewalls and port forwards.

Other Actiontec V1000H Guides

This is the reset router guide for the Actiontec V1000H Telus. We also have the following guides for the same router:

Reset the Actiontec V1000H

First, be sure the router remains on during the reset process. Do not unplug it or switch it off during this process. Doing so could cause permanent damage to your router.

Turn the router around so you are looking at the back panel. See the picture below.

router reset factory settings
This is the reset page from your Actiontec V1000H router.

Circled in red (in the image above) is the reset button. Press and hold this button for 10 seconds using a pin or unfolded paperclip. When you release the button the reset process should begin.

Don't forget that this will erase everything you have done to this router to make it yours. It's a good idea to try other troubleshooting techniques before you reset the Actiontec V1000H Telus router.

Login to the Actiontec V1000H

Now that you have reset the Actiontec V1000H Telus you need to login using the default username and password. If you need further assistance check out our Actiontec V1000H Telus Login Guide.

Change Your Password

Once you have finished logging into this router you should change the router's password. It's never a good idea to leave it as the default. If you need help thinking of a good password you can look at this Choosing a Strong Password guide for helpful tips.

Tip: Write this new password down so you don't forget it. You could attach it to the bottom of the router if you think you're likely to lose it.

Setup WiFi on the Actiontec V1000H Telus

The last setting that we recommend you fix immediately after resetting the Actiontec V1000H Telus router is the WiFi security. Some router companies leave the security open or disabled as the default. This means anyone within range of your Internet signal can use it with or without your permission. We highly recommend changing this to WPA2-PSK. If you need help we have a great guide for you called How to Setup WiFi on the Actiontec V1000H Telus.

Actiontec V1000H Help

Be sure to check out our other Actiontec V1000H info that you might be interested in.

This is the reset router guide for the Actiontec V1000H Telus. We also have the following guides for the same router: