How to change the IP Address on a Netgear FS726T router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

This page shows how to change the LAN IP Address on the Netgear FS726T router.

Other Netgear FS726T Guides

This is the ip address guide for the Netgear FS726T. We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

  • 192.168.0.1
  • 192.168.1.1
  • 10.0.0.1

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Netgear FS726T

To get started configuring the Netgear FS726T LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Netgear FS726T, follow our Netgear FS726T Login Guide.

Change the LAN IP Address on a Netgear FS726T

If you followed our login guide above then you should see this screen.

router status mac address internet IP
This is the status page from your Netgear FS726T router.

Now that you have finished logging into the Netgear FS726T you should begin on the System Status page. From here, to change your IP Address, the address you see when you are inside your local network, click the choice on the left side bar labeled Set-up.

Configure the LAN section of your Netgear FS726T

router setup
This is the setup page from your Netgear FS726T router.

You should now be on the System Setting page. Scroll down until you come to the bullet marked Static IP Address. Make sure this is marked, then place your cursor in the four boxes below this labeled IP Address. Enter your new address you have chosen for your Router in these boxes. One good choice for an address is 192.168.1.1

While changing this, make sure you do not change the Subnet Mask, this should remain at 255.255.255.0

Once you have finished making this change to your Router, click Apply.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other Netgear FS726T Info

Don't forget about our other Netgear FS726T info that you might be interested in.

This is the ip address guide for the Netgear FS726T. We also have the following guides for the same router: