This page shows how to change the DNS settings on the Buffalo WHR-HP-G54-Tomato router.
When you connect a router to the Internet it gets a few settings from your ISP automatically. One of the settings that the ISP sets in your router is the DNS setting. DNS stands for Domain Name System and it is used to convert Internet names into actual IP addresses. For instance, when you go to "google.com", your are really connecting to an IP address that is mapped through DNS to a number such as:
This mapping happens automatically every time you visit any page on the Internet.
Some ISPs choose to abuse the DNS system and map unknown names to servers that they control. This can be done in a way that you don't know it is happening since your router is getting its DNS settings from your ISP. For instance, if you have one of these ISPs who is hijacking your DNS, and you try to surf the web to "some-random-site.com" and "some-random-site.com" does not exist, you might get a page back from your ISP with local advertisements on it.
By changing your DNS setting in your router you will effectively change the DNS setting for every computer on your network. This is because when a device is connected to your network your router automatically hands out its own DNS settings to that device. This way you can protect your entire network from ISP hijacking with just one setting.
When you change the DNS settings in your router, you usually have to enter a Primary and a Secondary setting. The secondary is only used if the primary can not be located. Here are common settings:
If you want to use Google Public DNS, use the following settings:
If you want to use OpenDNS, use the following settings:
To get started configuring the Buffalo WHR-HP-G54-Tomato DNS page you need to login to your router. If you are already logged in you can skip this step.
To login to the Buffalo WHR-HP-G54-Tomato, follow our Buffalo WHR-HP-G54-Tomato Login Guide.
If you followed our login guide above then you should see this screen.
For the Buffalo WHR-HP-G54-Tomato router you begin on the System page. To change the DNS server settings click the link on the left labeled Basic, then Network below that.
You should now be on a page titled WAN/Internet.
Under the LAN section of this page is the Static DNS sub-category. In the first box that reads 0.0.0.0, replace that with the primary address of the DNS Server you are going to be using. In the next box below that, enter the secondary address of that DNS Server.
Click the Save button at the bottom of the page.
Most devices on your network will not begin using the new DNS settings until they have been rebooted. After rebooting a device you can go to it's network settings and verify that it is using the DNS servers that you specified.
Don't forget about our other Buffalo WHR-HP-G54-Tomato info that you might be interested in.