This article covers how to reset the Digisol DG-HR3300TA router back to factory default settings. Resetting a router is different than rebooting a router. Rebooting a router is simply turning it off and back on again. However, when you reset a router you, return it back to its factory default settings.
Warning: This is not a step to be taken lightly. When you reset your router, the following will happen.
- The router's username and password are reset to factory defaults.
- All WiFi settings are reset, including network name and password.
- All ISP settings will reset to default, and you may have to contact your ISP.
- Any parental controls, firewall settings, or port forwards will be removed.
A router reset is the last step you should take in recovering your router's password. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.
Other Digisol DG-HR3300TA Guides
This is the reset router guide for the Digisol DG-HR3300TA 39.92.1.3584. We also have the following guides for the same router:
Recover Password in Digisol DG-HR3300TA
Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.
Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.
Router Password Finder - Lost or Forgotten Router Password Recovery Tool
If you are unable to recover your lost router password, then you may have to proceed with a full router reset.
Reset the Digisol DG-HR3300TA
You can usually find a small reset button on either the back or the bottom of a router. A typical reset button looks like this:
Reset buttons are usually tiny. Yours may look slightly different than this. If you find a pinhole on the back of the router then that may be the reset button. You will need a paper clip to push it.
Hold the reset button down for 10 seconds and watch the lights. Notice how the lights on the front of the router are blinking. When the lights do something different, the router is reset. You can hold the button down as long as you like, it will not hurt anything.
Remember, this will totally reset your Digisol DG-HR3300TA router.
Only do this once you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.
Login to the Digisol DG-HR3300TA
Now you need to log in using the factory default username and password. You can find all of the information that you need in our DG-HR3300TA Login Guide.
Change Your Password
You need to change your router's default password after you log in for the first time. It's a very bad idea to leave your router's password set to the factory default. Our Choosing a Strong Password guide can help you pick a strong password for your router.
Tip: Write your new password down on a post-it note and stick it to the bottom of your router.
Other Digisol DG-HR3300TA Guides
We have collected a lot of information about the Digisol DG-HR3300TA router. You can find some of our additional content here.
This is the reset router guide for the Digisol DG-HR3300TA 39.92.1.3584. We also have the following guides for the same router: