How to change the IP Address on a Dlink DIR-330 router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

This page shows how to change the LAN IP Address on the Dlink DIR-330 router.

Other Dlink DIR-330 Guides

This is the ip address guide for the Dlink DIR-330. We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

  • 192.168.0.1
  • 192.168.1.1
  • 10.0.0.1

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Dlink DIR-330

To get started configuring the Dlink DIR-330 LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Dlink DIR-330, follow our Dlink DIR-330 Login Guide.

Change the LAN IP Address on a Dlink DIR-330

If you followed our login guide above then you should see this screen.

router setup
This is the setup page from your Dlink DIR-330 router.

After you have finished logging into the Dlink DIR-330 you begin on the Setup page of your Router. To change your IP Address, the address you can see while inside your network, click the box on the left labeled Network Settings.

Configure the LAN section of your Dlink DIR-330

router setup
This is the setup page from your Dlink DIR-330 router.

Once on this new page, scroll down the screen until you come to a box labeled Router IP Address and enter the new one you have chosen for you Router. We recommend using the address that is shown on this screenshot, 192.168.0.1

You want to leave a few things alone. The Subnet Mask, which should almost always be left at 255.255.255.0 and the DHCP Server should be left enabled, this allows the Router to choose these for you.

When you have finished changing things, click Save Settings, located near the top of the page.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other Dlink DIR-330 Info

Don't forget about our other Dlink DIR-330 info that you might be interested in.

This is the ip address guide for the Dlink DIR-330. We also have the following guides for the same router: