Setup Router logo in white Setup router name logo in white
Get Software

Reset the Dlink DWR-921

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 4 minutes

This is the reset guide for the Dlink DWR-921 router. A router reset is a much bigger deal than a router reboot. Unplugging a router from the wall reboots it. This is different from a reset because a reset completely erases all settings from the router.

Warning: Proceed with caution; resetting your router can be a major headache. The following settings will be changed in your router:

  • The router's username and password are reset.
  • All WiFi login information and network names are reset.
  • Your ISP username and password will be reset, and you may have to contact your ISP.
  • All parental controls, firewall settings, and port forwards will be removed.

A router reset should be considered the last resort when you cannot log in to your router any other way. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other Dlink DWR-921 Guides

This is the reset router guide for the Dlink DWR-921 v01.01.3.005. We also have the following guides for the same router:

Recover Password in Dlink DWR-921

If you are resetting your router because you forgot your router password, then you should try running our Router Password Finder first.

Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Just keep in mind that a router reset should be done as the last resort when you are unable to login to your router.

Reset the Dlink DWR-921

You can usually find a small reset button on either the back or the bottom of a router. Most reset buttons look like this:

Router Reset Button

Your reset button may look different, but usually they are very small. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.

Watch the front panel lights while you hold the reset button down for at least 10 seconds. After a few seconds the lights should blink differently. When this happens, the reset is complete. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.

Remember, this will erase everything you have previously done to this Dlink DWR-921 router.

Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the Dlink DWR-921

Now you need to log in using the factory default username and password. You can find all of the information that you need in our DWR-921 Login Guide.

Change Your Password

After logging in to your router for the first time, you need to change your router's password. It's a very bad idea to leave your router's password set to the factory default. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.

Tip: Write your new password down on a post-it note and stick it to the bottom of your router.

Other Dlink DWR-921 Guides

We have collected a lot of information about the Dlink DWR-921 router. You can find some of our additional content here.

This is the reset router guide for the Dlink DWR-921 v01.01.3.005. We also have the following guides for the same router: