This article covers how to reset the Gemtek WVRTM-130ACN router back to factory default settings. A router reset is a much bigger deal than a router reboot. Turning a router off and back on again causes a reboot. This is very different from a reset, which erases a router completely and returns it to factory default settings.
Warning: Proceed with caution; resetting your router can be a major headache. A router reset will affect the following settings:
- The router's login and password are reset.
- All WiFi settings are reset, including network name and password.
- Your ISP username and password will be reset, and you may have to contact your ISP.
- All parental controls, firewall settings, and port forwards will be removed.
Since a router reset is such a drastic step, it should only be done as a last resort when you cannot recover your router's password using any other methods. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.
Other Gemtek WVRTM-130ACN Guides
This is the reset router guide for the Gemtek WVRTM-130ACN 01.02.01.035 Imagine. We also have the following guides for the same router:
Recover Password in Gemtek WVRTM-130ACN
If the only reason that you are resetting your router is because you forgot your router password, then you may want to try running our Router Password Finder instead of resetting your router.
Router Password Finder can save you a ton of time by recovering your lost or forgotten router password instead of doing a full router reset.
Router Password Finder - Lost or Forgotten Router Password Recovery Tool
Just keep in mind that a router reset should be done as the last resort when you are unable to login to your router.
Reset the Gemtek WVRTM-130ACN
There is usually a small reset button located on either the back or the bottom of a router. This is what a typical reset button looks like:
Even though yours may look slightly different, you need to look for a tiny button. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.
Watch the front panel lights while you hold the reset button down for at least 10 seconds. After a few seconds the lights should blink differently. When this happens, the reset is complete. You can hold the button down as long as you like, it will not hurt anything.
Just don't forget that this will totally reset your Gemtek WVRTM-130ACN router.
Be sure to only reset your router if you have tried everything else, such as running our Router Password Finder software, which can find your lost or forgotten router password for you.
Login to the Gemtek WVRTM-130ACN
Once the reset is complete, you need to login to your router using the default IP address, username, and password. Just follow our WVRTM-130ACN Login Guide to find all of the information that you need.
Change Your Password
Do not forget to change your router's default password when you log back into it. The factory default passwords for routers are very well known. Our Choosing a Strong Password guide talks about choosing a strong password for your router.
Tip: Write your new password down on a post-it note and stick it to the bottom of your router.
Other Gemtek WVRTM-130ACN Guides
If you want additional help with your Gemtek WVRTM-130ACN be sure to check out some of our other guides.
This is the reset router guide for the Gemtek WVRTM-130ACN 01.02.01.035 Imagine. We also have the following guides for the same router: