If you need to reset your Hitron Technologies CODA-4582-U (2A) router back to factory settings, then this article shows you how. Resetting a router is different than rebooting a router. Turning a router off and back on again causes a reboot. This is different from a reset because a reset completely erases all settings from the router.
Warning: Since this erases everything you have done to the router, there are some things you need to consider first. When you reset your router, the following will happen.
- The router's login credentials are reset.
- All WiFi information such as network name, password, and authentication method are erased.
- All ISP settings will reset to default, and you may have to contact your ISP.
- All parental controls, firewall settings, and port forwards will be removed.
A router reset is the last step you should take in recovering your router's password. Make sure that you have tried to recover your router password using our Router Password Finder first.
Other Hitron Technologies CODA-4582-U (2A) Guides
This is the reset router guide for the Hitron Technologies CODA-4582-U (2A) 7.2.4.1.4b15. We also have the following guides for the same router:
Recover Password in Hitron Technologies CODA-4582-U (2A)
Before you resort to doing a full router reset, you may want to try running our Router Password Finder first.
Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.
Router Password Finder - Recover Lost or Forgotten Router Passwords
A router reset should be the last thing you try if you are unable to login.
Reset the Hitron Technologies CODA-4582-U (2A)
There is usually a small reset button located on either the back or the bottom of a router. Most reset buttons look like this:
Yours may look slightly different, but they are usually tiny. Sometimes the button is under a pinhole, and you need a paper clip to push it.
Watch the front panel lights while you hold the reset button down for at least 10 seconds. The blinking pattern of the lights on the front of the router should change when the reset is complete. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.
Remember, this will erase everything you have previously done to this Hitron Technologies CODA-4582-U (2A) router.
Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.
Login to the Hitron Technologies CODA-4582-U (2A)
After you are finished resetting your router, you need to login in using the original factory username and password. Just follow our CODA-4582-U (2A) Login Guide to find all of the information that you need.
Change Your Password
Do not forget to change your router's default password when you log back into it. It is a huge security risk to leave your router's password set to the factory default. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.
Tip: Write your new password down on a post-it note and stick it to the bottom of your router.
Other Hitron Technologies CODA-4582-U (2A) Guides
We have collected a lot of information about the Hitron Technologies CODA-4582-U (2A) router. You can find some of our additional content here.
This is the reset router guide for the Hitron Technologies CODA-4582-U (2A) 7.2.4.1.4b15. We also have the following guides for the same router: