This article covers how to reset the HooToo N300 router back to factory default settings. This is a much bigger deal than a router reboot. Turning a router off and back on again causes a reboot. This is very different from a reset, which erases a router completely and returns it to factory default settings.
Warning: Since this erases everything you have done to the router, there are some things you need to consider first. When you reset your router, the following will happen.
- The router's username and password are reset to factory defaults.
- All WiFi login information and network names are reset.
- Any ISP settings saved in your router will be removed. You may have to contact your ISP.
- All parental controls, firewall settings, and port forwards will be removed.
Since a router reset is such a drastic step, it should only be done as a last resort when you cannot recover your router's password using any other methods. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.
Other HooToo N300 Guides
This is the reset router guide for the HooToo N300. We also have the following guides for the same router:
Recover Password in HooToo N300
If you are resetting your router because you forgot your router password, then you should try running our Router Password Finder first.
Router Password Finder can save you a ton of time by recovering your lost or forgotten router password instead of doing a full router reset.
Router Password Finder - Recover Lost or Forgotten Router Passwords
Only after you have tried to recover your missing router username and password should you perform a full router reset.
Reset the HooToo N300
On most routers you can find a small button on the back or the bottom labeled reset. This is what a typical reset button looks like:
Reset buttons are usually tiny. Yours may look slightly different than this. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.
Hold the reset button down for about 10 seconds while watching the lights on the front of your router. The blinking pattern of the lights on the front of the router should change when the reset is complete. You cannot hold the button too long, and it will not hurt the router to hold the reset button down for longer than 10 seconds.
Don't forget, this step will totally reset your HooToo N300 router back to factory settings.
This last step should only be taken if you have tried everything else, such as using our Router Password Finder software, which can recover lost or forgotten router passwords.
Login to the HooToo N300
Now you need to log in using the factory default username and password. Our N300 Login Guide has all of the information that you need.
Change Your Password
Do not forget to change your router's default password when you log back into it. It's a very bad idea to leave your router's password set to the factory default. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.
Tip: After creating this new password, we highly recommend writing this down on a post-it note and attaching it to the bottom of your router for future reference.
Other HooToo N300 Guides
We have collected a lot of information about the HooToo N300 router. You can find some of our additional content here.
This is the reset router guide for the HooToo N300. We also have the following guides for the same router: