This page shows how to change the LAN IP Address on the Inteno DG301 iopsys router.
The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.
Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.
Common internal IP addresses for routers are:
It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.
To get started configuring the Inteno DG301 iopsys LAN page you need to login to your router. If you are already logged in you can skip this step.
To login to the Inteno DG301 iopsys, follow our Inteno DG301 iopsys Login Guide.
If you followed our login guide above then you should see this screen.
We begin this guide on the Status page of the Inteno DG301 iopsys router. To get started changing your IP address go to Network at the top of the page. From there click Interfaces.
On this new page be sure you're on the LAN tab. Then click General Setup.
You can now change your router's IP address. Enter your new address into the box labeled IPv4 address. Not sure what you should change it to? One good option is 192.168.1.1
Below that is the IPv4 netmask. Don't worry about changing this, it needs to stay at 255.255.255.0
Congratulations! That's all there is to it. Just be sure to save and apply your settings before leaving the page.
When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.
Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.
Don't forget about our other Inteno DG301 iopsys info that you might be interested in.