This guide shows you how to reset your Netgear RAX10 router to factory default settings. A router reset is a much bigger deal than a router reboot. Turning a router off and back on again causes a reboot. This is very different from a reset, which erases a router completely and returns it to factory default settings.
Warning: Proceed with caution; resetting your router can be a major headache. The following settings in your router will be changed:
- The router's login credentials are reset.
- Your WiFi login, password, and network name are reset.
- If your router has any ISP settings they will be removed, and you will have to contact your ISP.
- All port forwards, firewall settings, and parental controls that you have configured will be removed.
A router reset should be considered the last resort when you cannot log in to your router any other way. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.
Other Netgear RAX10 Guides
This is the reset router guide for the Netgear RAX10 v1.0.5.108. We also have the following guides for the same router:
Recover Password in Netgear RAX10
Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.
Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.
Router Password Finder - Lost or Forgotten Router Password Recovery Tool
Just keep in mind that a router reset should be done as the last resort when you are unable to login to your router.
Reset the Netgear RAX10
Most routers have a small button on either the back or the bottom. Most reset buttons look like this:
Reset buttons are usually tiny. Yours may look slightly different than this. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.
Keep an eye on the lights on the front of your router while holding the reset button down for about 10 seconds. The blinking pattern of the lights on the front of the router should change when the reset is complete. Do not worry about holding the button down too long; this is harmless.
Remember, this will totally reset your Netgear RAX10 router.
Only do this once you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.
Login to the Netgear RAX10
Now that you have finished resetting your router, you need to log in using the default username and password from the factory. We have a RAX10 Login Guide with all this information ready for you.
Change Your Password
You need to change your router's default password after you log in for the first time. It's a very bad idea to leave your router's password set to the factory default. Our Choosing a Strong Password guide talks about choosing a strong password for your router.
Tip: Write your new password down on a note and tape it to the bottom of your router for future reference.
Other Netgear RAX10 Guides
This isn't our only Netgear RAX10 guide. We also have the following guides for this router.
This is the reset router guide for the Netgear RAX10 v1.0.5.108. We also have the following guides for the same router: