Setup Router logo in white Setup router name logo in white
Get Software

How to change the IP Address on a Netgear WNR2000 router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 5 minutes

This page shows how to change the LAN IP Address on the Netgear WNR2000 router.

Other Netgear WNR2000 Guides

This is the ip address guide for the Netgear WNR2000 v3 Genie. We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

  • 192.168.0.1
  • 192.168.1.1
  • 10.0.0.1

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Netgear WNR2000

To get started configuring the Netgear WNR2000 LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Netgear WNR2000, follow our Netgear WNR2000 Login Guide.

Change the LAN IP Address on a Netgear WNR2000

If you followed our login guide above then you should see this screen.

router setup
This is the setup page from your Netgear WNR2000 router.

Once you've logged into the Netgear WNR2000v3 Genie router you should see the Home screen. To change your router's IP address go to the tab marked ADVANCED near the top of the page. From there click Setup and then LAN Setup below that.

Configure the LAN section of your Netgear WNR2000

router IP address lan home network
This is the lan page from your Netgear WNR2000 router.

This takes you to the page you see above.

Here you can change your IP Address. Enter your new address into the given boxes. Not sure what you should change it to? One good option is 10.0.0.1

Be sure not to change the IP Subnet Mask. This needs to stay at 255.255.255.0

That's all there is to it. Just don't forget to Apply your changes before closing the page.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other Netgear WNR2000 Info

Don't forget about our other Netgear WNR2000 info that you might be interested in.

This is the ip address guide for the Netgear WNR2000 v3 Genie. We also have the following guides for the same router: