Setup Router logo in white Setup router name logo in white
Get Software

Reset the Pentagram Cerberus P 6351

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 4 minutes

If you need to reset your Pentagram Cerberus P 6351 router back to factory settings, then this article shows you how. Resetting a router is different than rebooting a router. Rebooting a router is simply turning it off and back on again. This is very different from a reset, which erases a router completely and returns it to factory default settings.

Warning: This is not a step to be taken lightly. The following settings in your router will be changed:

  • The router's login credentials are reset.
  • Your WiFi login, password, and network name are reset.
  • Any ISP settings saved in your router will be removed. You may have to contact your ISP.
  • Any firewall settings, parental controls, and port forwards that you have configured will be removed.

A router reset should be considered the last resort when you cannot log in to your router any other way. Before you reset your router, you may want to try recovering your router password with our Router Password Finder.

Other Pentagram Cerberus P 6351 Guides

This is the reset router guide for the Pentagram Cerberus P 6351. We also have the following guides for the same router:

Recover Password in Pentagram Cerberus P 6351

If you are resetting your router because you forgot your router password, then you should try running our Router Password Finder first.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Do not do a full router reset until after you have tried every other option to log in to your router.

Reset the Pentagram Cerberus P 6351

Most of the time you can find a small reset button located on either the back or the bottom of a router. Most reset buttons look like this:

Router Reset Button

Reset buttons are usually tiny. Yours may look slightly different than this. If you find a pinhole on the back of the router then that may be the reset button. You will need a paper clip to push it.

Hold the reset button down for 10 seconds and watch the lights. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.

Just don't forget that this will totally reset your Pentagram Cerberus P 6351 router.

Only do this once you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the Pentagram Cerberus P 6351

Now that you have finished resetting the router, you need to login to the router interface using the default username and password. Just follow our Cerberus P 6351 Login Guide to find all of the information that you need.

Change Your Password

Be sure to change your router's default password after you get logged back in. Since factory passwords are well known, it's a huge security risk to leave your router set to the default. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.

Tip: Write your new password down on a note and tape it to the bottom of your router for future reference.

Other Pentagram Cerberus P 6351 Guides

If you want additional help with your Pentagram Cerberus P 6351 be sure to check out some of our other guides.

This is the reset router guide for the Pentagram Cerberus P 6351. We also have the following guides for the same router: