Reset the Ping Communication Infinitum V7610I1

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 3 minutes

In this article, you will learn how to reset your Ping Communication Infinitum V7610I1 back to factory settings. A router reset is a much bigger deal than a router reboot. Unplugging a router from the wall reboots it. Resetting a router erases all settings from it and returns it to factory defaults.

Warning: Proceed with caution; resetting your router can be a major headache. The following settings in your router will be changed:

  • The router's username and password are reset.
  • All WiFi login information and network names are reset.
  • Your ISP settings are reset, which means you will have to contact your ISP to get them back.
  • Any parental controls, firewall settings, or port forwards will be removed.

A router reset should be considered the last resort when you cannot log in to your router any other way. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.

Other Ping Communication Infinitum V7610I1 Guides

This is the reset router guide for the Ping Communication Infinitum V7610I1 v2 Telmex. We also have the following guides for the same router:

Recover Password in Ping Communication Infinitum V7610I1

Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Only after you have tried to recover your missing router username and password should you perform a full router reset.

Reset the Ping Communication Infinitum V7610I1

Most of the time you can find a small reset button located on either the back or the bottom of a router. Most reset buttons look like this:

Router Reset Button

Reset buttons are usually tiny. Yours may look slightly different than this. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.

Keep an eye on the lights on the front of your router while holding the reset button down for about 10 seconds. After a few seconds the lights should blink differently. When this happens, the reset is complete. You cannot hold the button too long, and it will not hurt the router to hold the reset button down for longer than 10 seconds.

Remember, this will totally reset your Ping Communication Infinitum V7610I1 router.

Be sure to only reset your router if you have tried everything else, such as running our Router Password Finder software, which can find your lost or forgotten router password for you.

Login to the Ping Communication Infinitum V7610I1

Now that you have finished resetting your router, you need to log in using the default username and password from the factory. We have a Infinitum V7610I1 Login Guide with all this information ready for you.

Change Your Password

Be sure to change your router's default password after you get logged back in. Since factory passwords are well known, it's a huge security risk to leave your router set to the default. Our Choosing a Strong Password guide talks about choosing a strong password for your router.

Tip: After creating this new password, we highly recommend writing this down on a post-it note and attaching it to the bottom of your router for future reference.

Other Ping Communication Infinitum V7610I1 Guides

We have collected a lot of information about the Ping Communication Infinitum V7610I1 router. You can find some of our additional content here.

This is the reset router guide for the Ping Communication Infinitum V7610I1 v2 Telmex. We also have the following guides for the same router: