Reset the Plusnet Hub Two

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 3 minutes

If you need to reset your Plusnet Hub Two router back to factory settings, then this article shows you how. A router reset is very different than a router reboot. Unplugging a router from the wall reboots it. However, when you reset a router you, return it back to its factory default settings.

Warning: Proceed with caution; resetting your router can be a major headache. A router reset will affect the following settings:

  • The router's login and password are reset to factory defaults.
  • Your WiFi login, password, and network name are reset.
  • Any ISP settings saved in your router will be removed. You may have to contact your ISP.
  • All parental controls, firewall settings, and port forwards will be removed.

Resetting your router should be considered the last step. Before you reset your router, you may want to try recovering your router password with our Router Password Finder.

Other Plusnet Hub Two Guides

This is the reset router guide for the Plusnet Hub Two v0.06.00.12134-PN. We also have the following guides for the same router:

Recover Password in Plusnet Hub Two

Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.

Router Password Finder can save you a ton of time by recovering your lost or forgotten router password instead of doing a full router reset.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Only after you have tried to recover your missing router username and password should you perform a full router reset.

Reset the Plusnet Hub Two

On most routers you can find a small button on the back or the bottom labeled reset. This is what a typical reset button looks like:

Router Reset Button

Reset buttons are usually tiny. Yours may look slightly different than this. Sometimes the button is under a pinhole, and you need a paper clip to push it.

Watch the lights on the front of your router and hold the reset button down for about 10 seconds. After a few seconds the lights should blink differently. When this happens, the reset is complete. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.

Remember, this will erase everything you have previously done to this Plusnet Hub Two router.

Be sure to only reset your router if you have tried everything else, such as running our Router Password Finder software, which can find your lost or forgotten router password for you.

Login to the Plusnet Hub Two

Now that you have finished resetting the router, you need to login to the router interface using the default username and password. Our Hub Two Login Guide has all of the information that you need.

Change Your Password

After logging in to your router for the first time, you need to change your router's password. The factory default passwords for routers are very well known. You can follow our Choosing a Strong Password guide to help you pick a solid password for your router.

Tip: Put your new password on a post-in note and stick it to the bottom of your router.

Other Plusnet Hub Two Guides

If you want additional help with your Plusnet Hub Two be sure to check out some of our other guides.

This is the reset router guide for the Plusnet Hub Two v0.06.00.12134-PN. We also have the following guides for the same router: