If you need to reset your Sagemcom Fast 4353-A router back to factory settings, then this article shows you how. A router reset is a much bigger deal than a router reboot. Unplugging a router from the wall reboots it. This is very different from a reset, which erases a router completely and returns it to factory default settings.
Warning: This is not a step to be taken lightly. The following settings in your router will be changed:
- The router's login credentials are reset to factory defaults.
- All WiFi information such as network name, password, and authentication method are erased.
- Your ISP username and password will be reset, and you may have to contact your ISP.
- All port forwards, firewall settings, and parental controls that you have configured will be removed.
A router reset should be considered the last resort when you cannot log in to your router any other way. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.
Other Sagemcom Fast 4353-A Guides
This is the reset router guide for the Sagemcom Fast 4353-A SG7M100000186 Belong. We also have the following guides for the same router:
Recover Password in Sagemcom Fast 4353-A
Before you resort to doing a full router reset, you may want to try running our Router Password Finder first.
Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.
Router Password Finder - Automatically Recover Lost or Forgotten Router Passwords
A router reset should be the last thing you try if you are unable to login.
Reset the Sagemcom Fast 4353-A
Most of the time you can find a small reset button located on either the back or the bottom of a router. A typical reset button looks like this:
Your reset button may look different, but usually they are very small. If you find a pinhole on the back of the router then that may be the reset button. You will need a paper clip to push it.
Watch the front panel lights while you hold the reset button down for at least 10 seconds. The lights on the front of the router should do something different when the reset happens. Do not be concerned about holding the reset button down too long. It will not hurt anything.
Just don't forget that this will totally reset your Sagemcom Fast 4353-A router.
Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.
Login to the Sagemcom Fast 4353-A
Once the reset is complete, you need to login to your router using the default IP address, username, and password. We have a Fast 4353-A Login Guide with all this information ready for you.
Change Your Password
After logging in to your router for the first time, you need to change your router's password. Leaving a router password set to default is a very serious security risk. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.
Tip: Write your new password down on a post-it note and stick it to the bottom of your router.
Other Sagemcom Fast 4353-A Guides
Here are some of our other Sagemcom Fast 4353-A guides that you might be interested in.
This is the reset router guide for the Sagemcom Fast 4353-A SG7M100000186 Belong. We also have the following guides for the same router: