If you need to reset your Sagemcom RAC2V2S router back to factory settings, then this article shows you how. A router reset is a much bigger deal than a router reboot. Every time your router loses power it reboots. Resetting a router erases all settings from it and returns it to factory defaults.
Warning: Since this erases everything you have done to the router, there are some things you need to consider first. The following settings will be changed in your router:
- The router's login credentials are reset to factory defaults.
- All WiFi information such as network name, password, and authentication method are erased.
- If your router has any ISP settings they will be removed, and you will have to contact your ISP.
- Any firewall settings, parental controls, or port forwards that you have configured will be removed.
Resetting your router should be considered the last step. Before you reset your router, you may want to try recovering your router password with our Router Password Finder.
Other Sagemcom RAC2V2S Guides
This is the reset router guide for the Sagemcom RAC2V2S SGAC11022A_prod Charter Spectrum. We also have the following guides for the same router:
Recover Password in Sagemcom RAC2V2S
Before you resort to doing a full router reset, you may want to try running our Router Password Finder first.
Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.
Router Password Finder - Lost or Forgotten Router Password Recovery Tool
If you are unable to recover your lost router password, then you may have to proceed with a full router reset.
Reset the Sagemcom RAC2V2S
There is usually a small reset button located on either the back or the bottom of a router. This is what a typical reset button looks like:
Reset buttons are usually tiny. Yours may look slightly different than this. If you find a pinhole on the back of the router then that may be the reset button. You will need a paper clip to push it.
Watch the lights on the front of your router and hold the reset button down for about 10 seconds. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. Do not be concerned about holding the reset button down too long. It will not hurt anything.
Don't forget, this step will totally reset your Sagemcom RAC2V2S router back to factory settings.
Be sure to only reset your router if you have tried everything else, such as running our Router Password Finder software, which can find your lost or forgotten router password for you.
Login to the Sagemcom RAC2V2S
Now that you have finished resetting the router, you need to login to the router interface using the default username and password. Just follow our RAC2V2S Login Guide to find all of the information that you need.
Change Your Password
You need to change your router's default password after you log in for the first time. It's a very bad idea to leave your router's password set to the factory default. Our Choosing a Strong Password guide can help you pick a strong password for your router.
Tip: After creating this new password, we highly recommend writing this down on a post-it note and attaching it to the bottom of your router for future reference.
Other Sagemcom RAC2V2S Guides
We have collected a lot of information about the Sagemcom RAC2V2S router. You can find some of our additional content here.
This is the reset router guide for the Sagemcom RAC2V2S SGAC11022A_prod Charter Spectrum. We also have the following guides for the same router: