Setup Router logo in white Setup router name logo in white
Get Software

Reset the Technicolor TG799vacXTREAM

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 3 minutes

This guide shows you how to reset your Technicolor TG799vacXTREAM router to factory default settings. A router reset is a much bigger deal than a router reboot. Turning a router off and back on again causes a reboot. This is very different from a reset, which erases a router completely and returns it to factory default settings.

Warning: Since this erases everything you have done to the router, there are some things you need to consider first. When you reset your router, the following will happen.

  • The router's login and password are reset.
  • All WiFi login information and network names are reset.
  • If your router has any ISP settings they will be removed, and you will have to contact your ISP.
  • All port forwards, firewall settings, and parental controls that you have configured will be removed.

Since a router reset is such a drastic step, it should only be done as a last resort when you cannot recover your router's password using any other methods. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other Technicolor TG799vacXTREAM Guides

This is the reset router guide for the Technicolor TG799vacXTREAM 17.1.7937 Telstra. We also have the following guides for the same router:

Recover Password in Technicolor TG799vacXTREAM

Before you resort to doing a full router reset, you may want to try running our Router Password Finder first.

Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

If you are unable to recover your lost router password, then you may have to proceed with a full router reset.

Reset the Technicolor TG799vacXTREAM

On most routers you can find a small button on the back or the bottom labeled reset. A typical reset button looks like this:

Router Reset Button

Yours may look slightly different, but they are usually tiny. You may need a paper clip to push the reset button.

Keep an eye on the lights on the front of your router while holding the reset button down for about 10 seconds. After a few seconds the lights should blink differently. When this happens, the reset is complete. You can hold the button down as long as you like, it will not hurt anything.

Remember, this will totally reset your Technicolor TG799vacXTREAM router.

Only do this once you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the Technicolor TG799vacXTREAM

Now that you have finished resetting the router, you need to login to the router interface using the default username and password. Just follow our TG799vacXTREAM Login Guide to find all of the information that you need.

Change Your Password

After logging in, you should really change your router's password for added security. It's a very bad idea to leave your router's password set to the factory default. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.

Tip: Write your new password down on a post-it note and stick it to the bottom of your router.

Other Technicolor TG799vacXTREAM Guides

We have collected a lot of information about the Technicolor TG799vacXTREAM router. You can find some of our additional content here.

This is the reset router guide for the Technicolor TG799vacXTREAM 17.1.7937 Telstra. We also have the following guides for the same router: