In this article, you will learn how to reset your TP-Link EX230v back to factory settings. A router reset is a much bigger deal than a router reboot. Rebooting a router is simply turning it off and back on again. This is different from a reset because a reset completely erases all settings from the router.
Warning: Make sure that you fully understand the following before resetting your router. When you reset your router, the following will happen.
- The router's login credentials are reset to factory defaults.
- All WiFi login information and network names are reset.
- If your router has any ISP settings they will be removed, and you will have to contact your ISP.
- Any parental controls, firewall settings, or port forwards will be removed.
A router reset should be considered the last resort when you cannot log in to your router any other way. Make sure that you have tried to recover your router password using our Router Password Finder first.
Other TP-Link EX230v Guides
This is the reset router guide for the TP-Link EX230v 0.11.0 2.00.0 v606d.0. We also have the following guides for the same router:
Recover Password in TP-Link EX230v
If the only reason that you are resetting your router is because you forgot your router password, then you may want to try running our Router Password Finder instead of resetting your router.
Router Password Finder is designed from the ground up to help you recover your forgotten router username and password, which can save you a lot of time.
Router Password Finder - Automatically Recover Lost or Forgotten Router Passwords
If you are unable to recover your lost router password, then you may have to proceed with a full router reset.
Reset the TP-Link EX230v
Most routers have a small button on either the back or the bottom. A typical reset button looks like this:
Reset buttons are usually tiny. Yours may look slightly different than this. You may need a paper clip to push the reset button.
Keep an eye on the lights on the front of your router while holding the reset button down for about 10 seconds. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. You cannot hold the button too long, and it will not hurt the router to hold the reset button down for longer than 10 seconds.
Just don't forget that this will totally reset your TP-Link EX230v router.
This last step should only be taken if you have tried everything else, such as using our Router Password Finder software, which can recover lost or forgotten router passwords.
Login to the TP-Link EX230v
Now that you have finished resetting the router, you need to login to the router interface using the default username and password. You can follow the EX230v Login Guide to find everything that you need to log in.
Change Your Password
Do not forget to change your router's default password when you log back into it. Leaving a router password set to default is a very serious security risk. You can follow our Choosing a Strong Password guide to help you pick a solid password for your router.
Tip: Write your new password down on a note and tape it to the bottom of your router for future reference.
Other TP-Link EX230v Guides
We have collected a lot of information about the TP-Link EX230v router. You can find some of our additional content here.
This is the reset router guide for the TP-Link EX230v 0.11.0 2.00.0 v606d.0. We also have the following guides for the same router: