Reset the Vtech NB403

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 3 minutes

If you need to reset your Vtech NB403 router back to factory settings, then this article shows you how. A router reset is very different than a router reboot. A reboot happens every time a router loses power. This is different from a reset because a reset completely erases all settings from the router.

Warning: Before you proceed, there are a few things you need to know. When you reset your router, the following will happen.

  • The router's login and password are reset.
  • Your WiFi login, password, and network name are reset.
  • Any ISP settings saved in your router will be removed. You may have to contact your ISP.
  • All port forwards, firewall settings, and parental controls that you have configured will be removed.

Since a router reset is such a drastic step, it should only be done as a last resort when you cannot recover your router's password using any other methods. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.

Other Vtech NB403 Guides

This is the reset router guide for the Vtech NB403 BI_2.02.07.07.23 Bezeq. We also have the following guides for the same router:

Recover Password in Vtech NB403

If the only reason that you are resetting your router is because you forgot your router password, then you may want to try running our Router Password Finder instead of resetting your router.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Automatically Recover Lost or Forgotten Router Passwords

Only after you have tried to recover your missing router username and password should you perform a full router reset.

Reset the Vtech NB403

Most routers have a small button on either the back or the bottom. A typical reset button looks like this:

Router Reset Button

Your reset button may look different, but usually they are very small. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.

Watch the lights on the front of your router and hold the reset button down for about 10 seconds. The lights on the front of the router should do something different when the reset happens. Do not worry about holding the button down too long; this is harmless.

Remember, this will erase everything you have previously done to this Vtech NB403 router.

Be sure to only reset your router if you have tried everything else, such as running our Router Password Finder software, which can find your lost or forgotten router password for you.

Login to the Vtech NB403

After you are finished resetting your router, you need to login in using the original factory username and password. You can follow the NB403 Login Guide to find everything that you need to log in.

Change Your Password

Be sure to change your router's default password after you get logged back in. Since factory passwords are well known, it's a huge security risk to leave your router set to the default. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.

Tip: A great place to write your new password down is on a piece of paper taped to the bottom of your router.

Other Vtech NB403 Guides

We have collected a lot of information about the Vtech NB403 router. You can find some of our additional content here.

This is the reset router guide for the Vtech NB403 BI_2.02.07.07.23 Bezeq. We also have the following guides for the same router: