How to change the IP Address on a ACorp Sprinter LAN420M router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

This page shows how to change the LAN IP Address on the ACorp Sprinter LAN420M router.

Other ACorp Sprinter LAN420M Guides

This is the ip address guide for the ACorp Sprinter LAN420M. We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

  • 192.168.0.1
  • 192.168.1.1
  • 10.0.0.1

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The ACorp Sprinter LAN420M

To get started configuring the ACorp Sprinter LAN420M LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the ACorp Sprinter LAN420M, follow our ACorp Sprinter LAN420M Login Guide.

Change the LAN IP Address on a ACorp Sprinter LAN420M

If you followed our login guide above then you should see this screen.

router status mac address internet IP
This is the status page from your ACorp Sprinter LAN420M router.

Once you have logged into the ACorp Sprinter-LAN420M you see the Home page of your Router. When you need to change your IP Address, the address you see when inside your network, click the Setup button at the top of the screen. Then on the left, click LAN Configuration.

On this new page, you either see the page in this screenshot or, you may see a choice in the middle section labeled LAN Group 1, you need to click the Configuration button next to this.

Configure the LAN section of your ACorp Sprinter LAN420M

router setup
This is the setup page from your ACorp Sprinter LAN420M router.

You should now be on the IP Settings page of your Router. Enter your new address you have chosen in the box labeled IP Address. Be sure to leave the Netmask at 255.255.255.0

When you have finished, make sure and save before you exit.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other ACorp Sprinter LAN420M Info

Don't forget about our other ACorp Sprinter LAN420M info that you might be interested in.

This is the ip address guide for the ACorp Sprinter LAN420M. We also have the following guides for the same router: