Reset the Arris BGW210-700

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 7 minutes

In this article, you will learn how to reset your Arris BGW210-700 back to factory settings. A router reset is very different than a router reboot. A reboot happens every time a router loses power. This is different from a reset because a reset completely erases all settings from the router.

Warning: This is not a step to be taken lightly. When you reset your router, the following will happen.

  • The router's login credentials are reset to factory defaults.
  • Your WiFi name and password are reset.
  • Your ISP settings are reset, which means you will have to contact your ISP to get them back.
  • All parental controls, firewall settings, and port forwards will be removed.

A router reset is the last step you should take in recovering your router's password. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other Arris BGW210-700 Guides

This is the reset router guide for the Arris BGW210-700 2.3.4 AT&T. We also have the following guides for the same router:

Recover Password in Arris BGW210-700

If you are resetting your router because you forgot your router password, then you should try running our Router Password Finder first.

Router Password Finder can save you a ton of time by recovering your lost or forgotten router password instead of doing a full router reset.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Do not do a full router reset until after you have tried every other option to log in to your router.

Reset the Arris BGW210-700

On most routers you can find a small button on the back or the bottom labeled reset. Most reset buttons look like this:

Router Reset Button

Even though yours may look slightly different, you need to look for a tiny button. If you find a pinhole on the back of the router then that may be the reset button. You will need a paper clip to push it.

Watch the front panel lights while you hold the reset button down for at least 10 seconds. Notice how the lights on the front of the router are blinking. When the lights do something different, the router is reset. You cannot hold the button too long, and it will not hurt the router to hold the reset button down for longer than 10 seconds.

Remember, this will erase everything you have previously done to this Arris BGW210-700 router.

This last step should only be taken if you have tried everything else, such as using our Router Password Finder software, which can recover lost or forgotten router passwords.

Login to the Arris BGW210-700

After you are finished resetting your router, you need to login in using the original factory username and password. We have a BGW210-700 Login Guide with all this information ready for you.

Change Your Password

Do not forget to change your router's default password when you log back into it. Since factory passwords are well known, it's a huge security risk to leave your router set to the default. Our Choosing a Strong Password guide can help you pick a strong password for your router.

Tip: Put your new password on a post-in note and stick it to the bottom of your router.

Other Arris BGW210-700 Guides

We have collected a lot of information about the Arris BGW210-700 router. You can find some of our additional content here.

This is the reset router guide for the Arris BGW210-700 2.3.4 AT&T. We also have the following guides for the same router: