How to change the IP Address on a Dlink DAP-1522-Bridge-Mode router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

This page shows how to change the LAN IP Address on the Dlink DAP-1522-Bridge-Mode router.

Other Dlink DAP-1522-Bridge-Mode Guides

This is the ip address guide for the Dlink DAP-1522-Bridge-Mode.We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Dlink DAP-1522-Bridge-Mode

To get started configuring the Dlink DAP-1522-Bridge-Mode LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Dlink DAP-1522-Bridge-Mode, follow our Dlink DAP-1522-Bridge-Mode Login Guide.

Change the LAN IP Address on a Dlink DAP-1522-Bridge-Mode

If you followed our login guide above then you should see this screen.

router status mac address internet IP
This is the status page from your Dlink router.

After you have logged into the Dlink DAP-1522-Bridge-Mode you are going to see the Device Information page of this Router. Next, click the tab at the top of the page labeled Setup, then Network Settings on the left. You are now on the correct page to change your Router IP Address, the address you are looking at inside your network.

Configure the LAN section of your Dlink DAP-1522-Bridge-Mode

router setup
This is the setup page from your Dlink router.

On this page, scroll down until you see the heading of LAN Settings. In this section place your cursor in the box labeled Access Point IP Address, and enter your new address you have picked out for your Router. One good recommendation is 192.168.0.1

Nothing else needs to be changed, just don't forget to save.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other Dlink DAP-1522-Bridge-Mode Info

Don't forget about our other Dlink DAP-1522-Bridge-Mode info that you might be interested in.

This is the ip address guide for the Dlink DAP-1522-Bridge-Mode.We also have the following guides for the same router: