Setup Router logo in white Setup router name logo in white
Get Software

How to Reset the Gigabyte GN-BR01G

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

On this page I will be showing you how to properly reset the Gigabyte GN-BR01G-WB01GS router back to factory defaults. It's important to know the difference between a reset and a reboot before we start.

  • Reboot: is simply a cycle in the power to the device.
  • Reset: is taking every single setting you have ever changed and reverting it back to factory defaults.

Warning: A reset erases every single setting you have ever changed on your device. We recommend creating a list of all setting you may of changed in the past such as:

  • The router's main username and password.
  • The wireless information such as name and password.
  • If this is a DSL router you need to re-enter the ISP (Internet Service Provider) username and password. Call your ISP for any details.
  • Write any other settings you have changed down such as IP addresses or port forwards.

Other Gigabyte GN-BR01G Guides

This is the reset router guide for the Gigabyte GN-BR01G WB01GS. We also have the following guides for the same router:

Reset the Gigabyte GN-BR01G

Normally at this point I would show you an image of the exact location of the Gigabyte GN-BR01G-WB01GS reset button. Unfortunately I was unable to find the exact location. It doesn't appear to be on the back panel so I would look on the side panels or under side of the router. The reset button is usually more of a pinhole than a button.

While the router is turned on, take a straightened paperclip and press down on the reset button for about 10 seconds to reset the Gigabyte GN-BR01G-WB01GS router. If you don't hold the reset button down for long enough you might end up only rebooting the router instead of resetting it like you wanted.

Remember a reset like this is going to erase every single setting you have ever changed on the device. We highly recommend trying other methods of troubleshooting before you continue.

Login to the Gigabyte GN-BR01G

Once you've reset the Gigabyte GN-BR01G-WB01GS router you'll need to log into it. This is done by using the factory default username and password. Don't know where to find these? We have them listed for your use in our Login Guide.

Tip: If the defaults aren't logging you in it could be because the reset wasn't held down for long enough.

Change Your Password

After you've reset and logged into your router we recommend setting a new password for it. Bear in mind this password will only protect your router settings, not your wireless network. All the same, setting a strong password is always a wise decision. For more help be sure to check out our Choosing a Strong Password Guide.

Tip: Afraid of losing your new password? Try writing it on a sticky note and attaching it to the underside of your router.

Setup WiFi on the Gigabyte GN-BR01G-WB01GS

It is time to start the reconfiguration process. This needs to include the wireless settings. If you are interested in a guide for this check out our easy to read How to Setup WiFi on the Gigabyte GN-BR01G-WB01GS page.

Gigabyte GN-BR01G Help

Be sure to check out our other Gigabyte GN-BR01G info that you might be interested in.

This is the reset router guide for the Gigabyte GN-BR01G WB01GS. We also have the following guides for the same router: