Huawei B593 WLAN Settings

This is the WLAN Settings screen from the Huawei B593 router.



Keywords on The Huawei B593 WLAN Settings Screenshot

The following words were detected on the Huawei B593 WLAN Settings screenshot.

General Settings - gt WLAN Settings WLAN Settings WLAN indicates the Wi-Fi network It provides Internet services for Wi-Fi devices You can enable or disable Wi-Fi services Note When WLAN parameters need to be modified the Wi-Fi hardware must be reinitialized This interrupts the WLAN for about 30 seconds General Settings WLAN nbsp nbsp Enable Mode nbsp 802 11b g 802 11g 802 11b 802 11n 802 11b g n Country Region nbsp Country Region nbsp Channel nbsp nbsp nbsp nbsp nbsp nbsp nbsp Current nbsp 11 802 11n bandwidth nbsp nbsp Rate nbsp Auto Transmit power nbsp 100 90 recommended 80 60 30 5 QoS nbsp nbsp Enable Interface Profile SSID nbsp nbsp nbsp nbsp nbsp nbsp 1-32 ASCII characters Maximum number of connected devices nbsp nbsp nbsp nbsp nbsp nbsp 1-32 Hide SSID broadcast nbsp nbsp Enable AP isolation nbsp nbsp Enable Security nbsp NONE not recommended WEP WPA-PSK WPA2-PSK recommended WPA-PSK WPA2-PSK Basic authentication nbsp Open Authentication Shared Authentication Both Authentication WPA2-PSK nbsp Disable Enable Intervals for sending authentication requests nbsp WPA-PSK nbsp nbsp nbsp nbsp nbsp nbsp 8-63 ASCII characters or 8-64 hex characters WPA encryption nbsp Encryption key length nbsp 128 Bit 64 Bit Current key index nbsp 1 2 3 4 Key 1 nbsp nbsp nbsp nbsp nbsp nbsp Key 2 nbsp nbsp nbsp nbsp nbsp nbsp Key 3 nbsp nbsp nbsp nbsp nbsp nbsp Key 4 nbsp nbsp nbsp nbsp nbsp nbsp nbsp nbsp nbsp Submit Cancel nbsp nbsp nbsp nbsp nbsp nbsp General Settings Indicates the settings of common control parameters of WLAN ports After WLAN is enabled the preset configurationt takes effect WLAN Wi-Fi configurations and functions are available only after WLAN is enabled Interface Profile Indicates the settings of common WLAN ports SSID indicates the WLAN port It should be changed to the name that is easy to remember Hide SSID broadcast after it is enabled WLAN ports are not be scanned However you must enter the SSID manually when a Wi-Fi device accesses the network AP isolation after it is enabled Wi-Fi devices in the WLAN cannot communicate with each other