How to change the IP Address on a Netgear WNDR4300v2 router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

This page shows how to change the LAN IP Address on the Netgear WNDR4300v2 router.

Other Netgear WNDR4300v2 Guides

This is the ip address guide for the Netgear WNDR4300v2.We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Netgear WNDR4300v2

To get started configuring the Netgear WNDR4300v2 LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Netgear WNDR4300v2, follow our Netgear WNDR4300v2 Login Guide.

Change the LAN IP Address on a Netgear WNDR4300v2

If you followed our login guide above then you should see this screen.

router status mac address internet IP
This is the status page from your Netgear router.

This guide begins on the Home page of the Netgear WNDR4300v2 router. To start off click Advanced near the top of the page. From there click Setup in the left hand sidebar and LAN Setup beneath that.

Configure the LAN section of your Netgear WNDR4300v2

router IP address lan home network
This is the lan page from your Netgear router.

You should be brought to the page shown above.

This page allows you to change your router's IP Address. Enter your new address into the given boxes. Don't know what you should change it to? A good choice to try is 10.0.0.1

Just beneath that you'll see the IP Subnet Mask. Be sure to leave this alone. It's important that this stay at 255.255.255.0

That's it! That's all there is to it. Just don't forget to Apply your changes before closing the page.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other Netgear WNDR4300v2 Info

Don't forget about our other Netgear WNDR4300v2 info that you might be interested in.

This is the ip address guide for the Netgear WNDR4300v2.We also have the following guides for the same router: