This is the WirelessAdvanced screen from the Nucom R5000UNv2 router.
The following words were detected on the Nucom R5000UNv2 WirelessAdvanced screenshot.
Wireless -- Advanced This page allows you to configure advanced features of the wireless LAN interface. You can select a particular channel on which to operate, force the transmission rate to a particular speed, set the fragmentation threshold, set the RTS threshold, set the wakeup interval for clients in power-save mode, set the beacon interval for the access point, set XPress mode and set whether short or long preambles are used. Click "Apply/Save" to configure the advanced wireless options. Band: 2.4GHz Channel: Current Channel: Auto Channel Timer(min) 802.11n/EWC: Bandwidth: Auto 20MHz in Both Bands 40MHz in Both Bands 20MHz in 2.4G Band and 40MHz in 5G Band Current Bandwidth: Control Sideband: Lower Upper Current Control Sideband: 802.11n Rate: 802.11n Protection: Off Auto Support 802.11n Client Only: Off On RIFS Advertisement: Off Auto OBSS Co-Existance: Disable Enable RX Chain Power Save: Disable Enable Power Save status: Full Power RX Chain Power Save Quiet Time: RX Chain Power Save PPS: Radio Power Save: Disable Enable Radio Power Save Quiet Time: Radio Power Save PPS: Radio Power Save On Time: --> 54g™ Rate: Multicast Rate: Basic Rate: Fragmentation Threshold: RTS Threshold: DTIM Interval: Beacon Interval: Global Max Clients: XPress™ Technology: Disabled Enabled 54g™ Mode: 54g Auto 54g Performance 54g LRS 802.11b Only 54g™ Protection: Off Auto Regulatory Mode: Disabled 802.11h 802.11d Pre-Network Radar Check: In-Network Radar Check: TPC Mitigation(db): 0(off) 2 3 4 Afterburner Technology: Disabled Enabled (Disable WMM for Selection) Preamble Type: long short Transmit Power: 20% 40% 60% 80% 100% WMM(Wi-Fi Multimedia): Auto Disabled Enabled WMM No Acknowledgement: Disabled Enabled WMM APSD: Disabled Enabled Iperf Support: Disable Enable Video Error Correction: RX Auto Enable Decode RX Disable Decode TX Enable Sequencer TX Enable Sequencer (IPTV Mode) TX Enable Encode TX Enable Encode (IPTV Mode)