In this article, you will learn how to reset your TP-Link Archer AX50 back to factory settings. This is a much bigger deal than a router reboot. Rebooting a router is simply turning it off and back on again. Resetting a router erases all settings from it and returns it to factory defaults.
Warning: Make sure that you fully understand the following before resetting your router. The following settings will be changed in your router:
- The router's login credentials are reset to factory defaults.
- All WiFi login information and network names are reset.
- Your ISP settings are reset, which means you will have to contact your ISP to get them back.
- Any port forwards, firewall settings, or parental controls that you have configured will be removed.
Since a router reset is such a drastic step, it should only be done as a last resort when you cannot recover your router's password using any other methods. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.
Other TP-Link Archer AX50 Guides
This is the reset router guide for the TP-Link Archer AX50 1.0.11. We also have the following guides for the same router:
Recover Password in TP-Link Archer AX50
If the only reason that you are resetting your router is because you forgot your router password, then you may want to try running our Router Password Finder instead of resetting your router.
Router Password Finder can save you a ton of time by recovering your lost or forgotten router password instead of doing a full router reset.
Router Password Finder - Recover Lost or Forgotten Router Passwords
Just keep in mind that a router reset should be done as the last resort when you are unable to login to your router.
Reset the TP-Link Archer AX50
Most routers have a small button on either the back or the bottom. Look at your router and try to find something that looks like this:
Reset buttons are usually tiny. Yours may look slightly different than this. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.
Keep an eye on the lights on the front of your router while holding the reset button down for about 10 seconds. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.
Remember, this will totally reset your TP-Link Archer AX50 router.
Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.
Login to the TP-Link Archer AX50
Now you need to log in using the factory default username and password. Our Archer AX50 Login Guide has all of the information that you need.
Change Your Password
You need to change your router's default password after you log in for the first time. Leaving a router password set to default is a very serious security risk. Our Choosing a Strong Password guide can help you pick a strong password for your router.
Tip: Write your new password down on a note and tape it to the bottom of your router for future reference.
Other TP-Link Archer AX50 Guides
If you want additional help with your TP-Link Archer AX50 be sure to check out some of our other guides.
This is the reset router guide for the TP-Link Archer AX50 1.0.11. We also have the following guides for the same router: