This guide shows you how to reset your TP-Link Archer C60 router. Resetting a router is different than rebooting a router. Rebooting a router is simply turning it off and back on again. A Router Reset completely erases the router and returns it to factory settings.
Warning: Make sure that you fully understand the following before resetting your router. A router reset will affect the following settings:
- The router's login credentials are reset.
- All WiFi login information and network names are reset.
- Your ISP settings are reset, which means you will have to contact your ISP to get them back.
- Any parental controls, firewall settings, or port forwards will be removed.
Since a router reset is such a drastic step, it should only be done as a last resort when you cannot recover your router's password using any other methods. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.
Other TP-Link Archer C60 Guides
This is the reset router guide for the TP-Link Archer C60 v2.0.0. We also have the following guides for the same router:
Recover Password in TP-Link Archer C60
If you are resetting your router because you forgot your router password, then you should try running our Router Password Finder first.
Router Password Finder can save you a ton of time by recovering your lost or forgotten router password instead of doing a full router reset.
Router Password Finder - Recover Lost or Forgotten Router Passwords
A router reset should be the last thing you try if you are unable to login.
Reset the TP-Link Archer C60
Most routers have a small button on either the back or the bottom. A typical reset button looks like this:
Reset buttons are usually tiny. Yours may look slightly different than this. Sometimes the button is under a pinhole, and you need a paper clip to push it.
Hold the reset button down for 10 seconds and watch the lights. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. Do not be concerned about holding the reset button down too long. It will not hurt anything.
Remember, this will totally reset your TP-Link Archer C60 router.
Only do this once you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.
Login to the TP-Link Archer C60
Once the reset is complete, you need to login to your router using the default IP address, username, and password. You can follow the Archer C60 Login Guide to find everything that you need to log in.
Change Your Password
Do not forget to change your router's default password when you log back into it. Since factory passwords are well known, it's a huge security risk to leave your router set to the default. Our Choosing a Strong Password guide can help you pick a strong password for your router.
Tip: After creating this new password, we highly recommend writing this down on a post-it note and attaching it to the bottom of your router for future reference.
Other TP-Link Archer C60 Guides
We have collected a lot of information about the TP-Link Archer C60 router. You can find some of our additional content here.
This is the reset router guide for the TP-Link Archer C60 v2.0.0. We also have the following guides for the same router: