This is the reset guide for the TP-Link Archer C8 v3 router. Resetting a router is different than rebooting a router. Turning a router off and back on again causes a reboot. However, when you reset a router you, return it back to its factory default settings.
Warning: Make sure that you fully understand the following before resetting your router. When you reset your router, the following will happen.
- The router's login credentials are reset to factory defaults.
- All WiFi login information and network names are reset.
- All ISP settings will reset to default, and you may have to contact your ISP.
- Any firewall settings, parental controls, and port forwards that you have configured will be removed.
A router reset is the last step you should take in recovering your router's password. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.
Other TP-Link Archer C8 v3 Guides
This is the reset router guide for the TP-Link Archer C8 v3. We also have the following guides for the same router:
Recover Password in TP-Link Archer C8 v3
Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.
Router Password Finder can save you a ton of time by recovering your lost or forgotten router password instead of doing a full router reset.
Router Password Finder - Recover Lost or Forgotten Router Passwords
If you are unable to recover your lost router password, then you may have to proceed with a full router reset.
Reset the TP-Link Archer C8 v3
Usually there is a reset button located on the back or bottom of a router. A typical reset button looks like this:
Yours may look slightly different, but they are usually tiny. Sometimes the reset button is under a pinhole on the back of the router, and you need a paper clip to push it.
Watch the front panel lights while you hold the reset button down for at least 10 seconds. The blinking pattern of the lights on the front of the router should change when the reset is complete. Do not worry about holding the button down too long; this is harmless.
Remember, this will totally reset your TP-Link Archer C8 v3 router.
Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.
Login to the TP-Link Archer C8 v3
Now that you have finished resetting the router, you need to login to the router interface using the default username and password. Our Archer C8 v3 Login Guide has all of the information that you need.
Change Your Password
Be sure to change your router's default password after you get logged back in. It is a huge security risk to leave your router's password set to the factory default. Our Choosing a Strong Password guide talks about choosing a strong password for your router.
Tip: Write your new password down on a note and tape it to the bottom of your router for future reference.
Other TP-Link Archer C8 v3 Guides
This isn't our only TP-Link Archer C8 v3 guide. We also have the following guides for this router.
This is the reset router guide for the TP-Link Archer C8 v3. We also have the following guides for the same router: