How to change the IP Address on a TP-Link TD-W8910G router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

This page shows how to change the LAN IP Address on the TP-Link TD-W8910G router.

Other TP-Link TD-W8910G Guides

This is the ip address guide for the TP-Link TD-W8910G. We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

  • 192.168.0.1
  • 192.168.1.1
  • 10.0.0.1

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The TP-Link TD-W8910G

To get started configuring the TP-Link TD-W8910G LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the TP-Link TD-W8910G, follow our TP-Link TD-W8910G Login Guide.

Change the LAN IP Address on a TP-Link TD-W8910G

If you followed our login guide above then you should see this screen.

router status mac address internet IP
This is the status page from your TP-Link TD-W8910G router.

Once you have logged into the TP-Link TD-W8910G you should begin on the Device Info page of this Router. When you need to change your Router IP Address, the address you are going to see when inside the network, click the choice on the left labeled Advanced Setup, then LAN.

Configure the LAN section of your TP-Link TD-W8910G

router setup
This is the setup page from your TP-Link TD-W8910G router.

This should take you to a page called Local Area Network (LAN) Setup. Place your cursor in the box labeled IP Address and enter the address you have chosen for your TP-Link Router. We suggest using an address of 192.168.0.1

Most everything else on this page should be left as it is, such as the Subnet Mask, which is the access point that your network sees, and needs to be at 255.255.255.0

When you are finished you will need to click Save/Reboot.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other TP-Link TD-W8910G Info

Don't forget about our other TP-Link TD-W8910G info that you might be interested in.

This is the ip address guide for the TP-Link TD-W8910G. We also have the following guides for the same router: