Reset the Arris TG4482A

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 4 minutes

This guide shows you how to reset your Arris TG4482A router. This is a much bigger deal than a router reboot. Turning a router off and back on again causes a reboot. However, when you reset a router you, return it back to its factory default settings.

Warning: Proceed with caution; resetting your router can be a major headache. The following settings will be changed in your router:

  • The router's username and password are reset to factory defaults.
  • All WiFi information such as network name, password, and authentication method are erased.
  • All ISP settings will reset to default, and you may have to contact your ISP.
  • All parental controls, firewall settings, and port forwards will be removed.

A router reset is the last step you should take in recovering your router's password. You should be sure that you have tried to at least recover your router password using our Router Password Finder before resorting to a router reset.

Other Arris TG4482A Guides

This is the reset router guide for the Arris TG4482A TG4482PC2_5.8p11s6_PROD_sey Xfinity. We also have the following guides for the same router:

Recover Password in Arris TG4482A

If the only reason that you are resetting your router is because you forgot your router password, then you may want to try running our Router Password Finder instead of resetting your router.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Recover Lost or Forgotten Router Passwords

Do not do a full router reset until after you have tried every other option to log in to your router.

Reset the Arris TG4482A

Most of the time you can find a small reset button located on either the back or the bottom of a router. A typical reset button looks like this:

Router Reset Button

Reset buttons are usually tiny. Yours may look slightly different than this. Sometimes the button is under a pinhole, and you need a paper clip to push it.

Watch the front panel lights while you hold the reset button down for at least 10 seconds. The lights on the front of the router should do something different when the reset happens. Do not worry about holding the button down too long; this is harmless.

Keep in mind that this will completely reset your Arris TG4482A router.

Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the Arris TG4482A

Once the reset is complete, you need to login to your router using the default IP address, username, and password. We have a TG4482A Login Guide with all this information ready for you.

Change Your Password

After logging in, you should really change your router's password for added security. Leaving a router password set to default is a very serious security risk. Our Choosing a Strong Password guide can help you pick a strong password for your router.

Tip: A great place to write your new password down is on a piece of paper taped to the bottom of your router.

Other Arris TG4482A Guides

If you want additional help with your Arris TG4482A be sure to check out some of our other guides.

This is the reset router guide for the Arris TG4482A TG4482PC2_5.8p11s6_PROD_sey Xfinity. We also have the following guides for the same router: