Setup Router logo in white Setup router name logo in white
Get Software

How to Reset the Dynamode BR6004W-G2M

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

On this page I will be showing you how to reset the Dynamode BR-6004W-G2M router back to factory defaults. A lot of people confuse the words reset and reboot. When you reboot a router you cycle the power to the unit. When you reset this router you will be erasing every single setting you have ever changed and returning them to factory defaults.

Warning: A reset like the one you are doing here is a big step and shouldn't be taken lightly. Take the time to make a list of any settings you have changed in the past. The following list contains some of the more commonly changed settings.

  • The router's interface username and password.
  • The Internet name and password.
  • If you are resetting a DSL router you need to re-enter the ISP or Internet Service Provider username and password. Call your ISP for this information.
  • Other possibilities are port forwards, and IP address changes.

Other Dynamode BR6004W-G2M Guides

This is the reset router guide for the Dynamode BR6004W-G2M. We also have the following guides for the same router:

Reset the Dynamode BR6004W-G2M

Do you know where the reset button is located? Below is a picture of a similar router. Take a look at where this reset button is located and see if you can find yours on the Dynamode BR-6004W-G2M router. This reset button is typically a recessed hole to avoid accidental resets.

router reset factory settings
This is the reset page from your Dynamode BR6004W-G2M router.

Once you have located the reset button you need to take a straightened paperclip and press down on the button for about 10 seconds. Do this while the router is on. If you don't hold this button down for long enough you might end up only rebooting the device instead of resetting it like you wanted.

Please remember a reset like this one is going to erase every single setting you have ever changed on this unit. We strongly recommend exhausting your other troubleshooting methods first.

Login to the Dynamode BR6004W-G2M

Following that you'll need to log into your Dynamode BR-6004W-G2M router. Do this by using the factory default username and password. Not sure where to get these? We have them provided for you in our Login Guide.

Tip: If the defaults aren't logging you in it might be because the reset button wasn't held down for long enough.

Change Your Password

Once you've logged into your router we suggest setting a new password for it. This can be whatever you want it to be, however keep in mind that this password will only protect your router settings, not your wireless network. All the same, setting a strong password is always a good idea. For help in doing so take a look through our Choosing a Strong Password Guide.

Tip: Afraid of losing your new password? Try writing it on a sticky note and attaching it to the bottom of your router.

Setup WiFi on the Dynamode BR-6004W-G2M

Finally you can begin the reconfiguration process. This needs to include the WiFi settings. Take a look at our How to Setup WiFi on the Dynamode BR-6004W-G2M page for a great guide on the wireless topic.

Dynamode BR6004W-G2M Help

Be sure to check out our other Dynamode BR6004W-G2M info that you might be interested in.

This is the reset router guide for the Dynamode BR6004W-G2M. We also have the following guides for the same router: