Setup Router logo in white Setup router name logo in white
Get Software

Reset the Humax BGW320-500

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 4 minutes

This guide shows you how to reset your Humax BGW320-500 router to factory default settings. Resetting a router is different than rebooting a router. A reboot happens every time a router loses power. This is different from a reset because a reset completely erases all settings from the router.

Warning: Proceed with caution; resetting your router can be a major headache. The following settings in your router will be changed:

  • The router's login and password are reset.
  • All WiFi settings are reset, including network name and password.
  • Your ISP username and password will be reset, and you may have to contact your ISP.
  • Any parental controls, firewall settings, or port forwards will be removed.

Since a router reset is such a drastic step, it should only be done as a last resort when you cannot recover your router's password using any other methods. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other Humax BGW320-500 Guides

This is the reset router guide for the Humax BGW320-500 3.19.5 AT&T. We also have the following guides for the same router:

Recover Password in Humax BGW320-500

Before you resort to doing a full router reset, you may want to try running our Router Password Finder first.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Automatically Recover Lost or Forgotten Router Passwords

Only after you have tried to recover your missing router username and password should you perform a full router reset.

Reset the Humax BGW320-500

On most routers you can find a small button on the back or the bottom labeled reset. What you are looking for is something that looks like this:

Router Reset Button

Even though yours may look slightly different, you need to look for a tiny button. If you find a pinhole on the back of the router then that may be the reset button. You will need a paper clip to push it.

Watch the front panel lights while you hold the reset button down for at least 10 seconds. Notice how the lights on the front of the router are blinking. When the lights do something different, the router is reset. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.

Remember, this will erase everything you have previously done to this Humax BGW320-500 router.

Be sure to only reset your router if you have tried everything else, such as running our Router Password Finder software, which can find your lost or forgotten router password for you.

Login to the Humax BGW320-500

Once the reset is complete, you need to login to your router using the default IP address, username, and password. Our BGW320-500 Login Guide has all of the information that you need.

Change Your Password

Be sure to change your router's default password after you get logged back in. Since factory passwords are well known, it's a huge security risk to leave your router set to the default. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.

Tip: Write your new password down on a post-it note and stick it to the bottom of your router.

Other Humax BGW320-500 Guides

If you want additional help with your Humax BGW320-500 be sure to check out some of our other guides.

This is the reset router guide for the Humax BGW320-500 3.19.5 AT&T. We also have the following guides for the same router: