Setup Router logo in white Setup router name logo in white
Get Software

Reset the LB-Link BL-WR3000

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 3 minutes

If you need to reset your LB-Link BL-WR3000 router back to factory settings, then this article shows you how. This is a much bigger deal than a router reboot. Unplugging a router from the wall reboots it. However, when you reset a router you, return it back to its factory default settings.

Warning: Since this erases everything you have done to the router, there are some things you need to consider first. The following settings will be changed in your router:

  • The router's username and password are reset to factory defaults.
  • All WiFi login information and network names are reset.
  • If your router has any ISP settings they will be removed, and you will have to contact your ISP.
  • Any firewall settings, parental controls, or port forwards that you have configured will be removed.

A router reset is the last step you should take in recovering your router's password. Before you reset your router, you may want to try recovering your router password with our Router Password Finder.

Other LB-Link BL-WR3000 Guides

This is the reset router guide for the LB-Link BL-WR3000 v2. We also have the following guides for the same router:

Recover Password in LB-Link BL-WR3000

Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Only after you have tried to recover your missing router username and password should you perform a full router reset.

Reset the LB-Link BL-WR3000

You can usually find a small reset button on either the back or the bottom of a router. Look for something that looks like this:

Router Reset Button

Reset buttons are usually tiny. Yours may look slightly different than this. Sometimes the button is under a pinhole, and you need a paper clip to push it.

Watch the lights on the front of your router and hold the reset button down for about 10 seconds. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.

Keep in mind that this will completely reset your LB-Link BL-WR3000 router.

Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the LB-Link BL-WR3000

Now that you have finished resetting your router, you need to log in using the default username and password from the factory. Just follow our BL-WR3000 Login Guide to find all of the information that you need.

Change Your Password

You need to change your router's default password after you log in for the first time. It's a very bad idea to leave your router's password set to the factory default. You can follow our Choosing a Strong Password guide to help you pick a solid password for your router.

Tip: Write your new password down on a post-it note and stick it to the bottom of your router.

Other LB-Link BL-WR3000 Guides

If you want additional help with your LB-Link BL-WR3000 be sure to check out some of our other guides.

This is the reset router guide for the LB-Link BL-WR3000 v2. We also have the following guides for the same router: