How to change the IP Address on a Linksys WAG320N router

This page shows how to change the LAN IP Address on the Linksys WAG320N router.

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

192.168.0.1
192.168.1.1
10.0.0.1

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Linksys WAG320N

To get started configuring the Linksys WAG320N LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Linksys WAG320N, follow our Linksys WAG320N Login Guide.

Change the LAN IP Address on a Linksys WAG320N

If you followed our login guide above then you should see this screen.

router setup — This is the *setup* page from your Linksys WAG320N router.

To change your IP Address, the address you can see while inside your network, first log into the Linksys WAG320N. This places you on the Setup page. Next, click Basic Setuplocated at the top of the page.

Configure the LAN section of your Linksys WAG320N

Scroll down this page until you come to the section labeled Network Setup (LAN). In this section there should be four boxes labeled Local IP Address. Place your cursor in the first of these four boxes and begin typing in your new IP Address. Our recommendation is to use the address of 192.168.1.1

You need to leave the Subnet Mask at 255.255.255.0, and the DHCP Server should be left enabled.

Once you have finished making changes to your Router, click Save Settings.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.