How to change the IP Address on a Linksys WAG54G router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 4 minutes

This page shows how to change the LAN IP Address on the Linksys WAG54G router.

Other Linksys WAG54G Guides

This is the ip address guide for the Linksys WAG54G v2.We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Linksys WAG54G

To get started configuring the Linksys WAG54G LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Linksys WAG54G, follow our Linksys WAG54G Login Guide.

Change the LAN IP Address on a Linksys WAG54G

If you followed our login guide above then you should see this screen.

router setup
This is the setup page from your Linksys router.

Now that you have logged into the Linksys WAG54Gv2 you see the Setup page. When you decide to change your IP Address, the address you be looking at while you're inside your network, click Basic Setup.

Configure the LAN section of your Linksys WAG54G

router setup
This is the setup page from your Linksys router.

Next to this, there should be four boxes in a row labeled Local IP Address, enter your new address here. For your Router we suggest using 192.168.1.1

Leave the Subnet Mask at 255.255.255.0, and the DHCP Server should be left enabled.

Once you're done making changes to your Router IP Address, you will need to save.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other Linksys WAG54G Info

Don't forget about our other Linksys WAG54G info that you might be interested in.

This is the ip address guide for the Linksys WAG54G v2.We also have the following guides for the same router: