Setup Router logo in white Setup router name logo in white
Get Software

How to Reset the Linksys WAP4400N

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

On this page I describe how to reset the Linksys WAP4400N router if you are unable to access the router setup pages.

There seems to be confusion between the terms reset and reboot. When you reboot a router you are only cycling the power to the unit. When you reset the router you are taking all the settings and reverting them all to factory defaults. All your personal data is lost.

Warning: A reset is not to be taken lightly. I recommend making a list of the settings you will need to reconfigure after the reset is finished. This list should include every change you have made such as:

  • the router's main username and password used to access the router setup pages.
  • The WiFi information such as the network name and password.
  • If you are resetting a DSL router you need to re-enter the Internet Service Provider (ISP) username and password. Call your service provider for these details.
  • Other settings you may forget are port forwards, IP addresses, DNS servers, parental controls...

Other Linksys WAP4400N Guides

This is the reset router guide for the Linksys WAP4400N. We also have the following guides for the same router:

Reset the Linksys WAP4400N

Take a look at the image below. I have circled the reset button for you in red. This button is recessed to avoid accidental resets so you need to use a sharp object such as a pin or straightened paperclip.

router reset factory settings
This is the reset page from your Linksys WAP4400N router.

First of all make sure the router is plugged in and turned on. Then take the small sharp object of your choice and press down on the reset button for about 10 seconds. This begins the reset process which can take several minutes to complete. If you don't hold the reset button down for long enough you might end up only rebooting the router instead of resetting it like you wanted.

Caution: DO NOT unplug or turn off the router during this process. If you do you run the risk of permanently damaging the router.

It is important that you remember this type of reset erases all your personal data. If you want or need to avoid this loss you must use a different method of solving your problem.

Login to the Linksys WAP4400N

After the reset is complete you will need to login to your Linksys WAP4400N router. This can be accomplished by using the default IP address, password, and username. If you aren't sure what these are, you can check them out in our Linksys WAP4400N Login Guide.

Tip: Can't login with the defaults? You might have improperly reset the router. Try resetting it again but hold down the reset button for a little longer.

Change Your Password

Next, you should change the password for your router. The default password is not very secure and can leave your router at risk. Visit our Choosing a Strong Password guide to get started on making a secure password.

Tip: Keep from losing your password by writing it down on a note of some kind and placing it under the router.

Setup WiFi on the Linksys WAP4400N

As you begin reconfiguring the router settings, don't forget to also configure the wireless settings. Check out our easy to follow Linksys WAP4400N WiFi Instructions to get started on securing your network.

Linksys WAP4400N Help

Be sure to check out our other Linksys WAP4400N info that you might be interested in.

This is the reset router guide for the Linksys WAP4400N. We also have the following guides for the same router: