How to change the IP Address on a Linksys WRT600N router

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 3 minutes

This page shows how to change the LAN IP Address on the Linksys WRT600N router.

Other Linksys WRT600N Guides

This is the ip address guide for the Linksys WRT600N.We also have the following guides for the same router:

What is the LAN IP Address of a Router

The LAN IP Address of a router is also known as its internal IP address. It is also the IP address that you connect to when you want to configure your router. It is only useful from inside your network and has no use from the Internet side.

Routers have 2 IP addresses: an internal ip address and an external ip address. The external IP address is assigned to you by your Internet Service Provider, or ISP, and is generally not something that you can change. The internal IP address is set to a default value at the factory but can be changed if you want.

Common internal IP addresses for routers are:

It is generally a good idea to make the last number of your router's internal IP address a '1', as in 192.168.0.1 or 10.0.0.1. This is not necessary, but many people do it and it makes it a bit easier to remember which IP address is assigned to your router. If you want to change the internal IP address of your router, this guide shows you how.

Login To The Linksys WRT600N

To get started configuring the Linksys WRT600N LAN page you need to login to your router. If you are already logged in you can skip this step.

To login to the Linksys WRT600N, follow our Linksys WRT600N Login Guide.

Change the LAN IP Address on a Linksys WRT600N

If you followed our login guide above then you should see this screen.

router setup
This is the setup page from your Linksys router.

When you have successfully logged into the Linksys WRT600N you should see the Basic Setup page. This page allows you to make some general changes, including the IP Address, the address your Router sees while you are inside your network.

Configure the LAN section of your Linksys WRT600N

router setup
This is the setup page from your Linksys router.

Find the heading on the left labeled Network Setup. Next to this are four boxes labeled IP Address, enter your new address you have picked out for your Router. Our suggestion is to use an address such as the one seen in these screenshots, 192.168.1.1

You need to leave the Subnet Mask at 255.255.255.0

Finally, save by clicking the Save Settings button.

Possible Problems when Changing your LAN IP Address

When you change your LAN IP Address you are making a fundamental change to how your network functions and all computers on your network will be affected. You will lose your Internet connection when you apply these changes. Your router may reboot and require a couple of minutes to start responding again.

Also note that some computers may need to be rebooted after you make this change before they can talk to the router or on the Internet again.

Other Linksys WRT600N Info

Don't forget about our other Linksys WRT600N info that you might be interested in.

This is the ip address guide for the Linksys WRT600N.We also have the following guides for the same router: