Setup Router logo in white Setup router name logo in white
Get Software

Reset the Netcomm 3G10WVT

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 3 minutes

If you need to reset your Netcomm 3G10WVT router back to factory settings, then this article shows you how. This is a much bigger deal than a router reboot. Unplugging a router from the wall reboots it. This is different from a reset because a reset completely erases all settings from the router.

Warning: Make sure that you fully understand the following before resetting your router. A router reset will affect the following settings:

  • The router's login and password are reset.
  • All WiFi settings are reset, including network name and password.
  • Any ISP settings saved in your router will be removed. You may have to contact your ISP.
  • Any firewall settings, parental controls, and port forwards that you have configured will be removed.

A router reset is the last step you should take in recovering your router's password. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other Netcomm 3G10WVT Guides

This is the reset router guide for the Netcomm 3G10WVT. We also have the following guides for the same router:

Recover Password in Netcomm 3G10WVT

If the only reason that you are resetting your router is because you forgot your router password, then you may want to try running our Router Password Finder instead of resetting your router.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Automatically Recover Lost or Forgotten Router Passwords

A router reset should be the last thing you try if you are unable to login.

Reset the Netcomm 3G10WVT

Most routers have a small button on either the back or the bottom. A typical reset button looks like this:

Router Reset Button

Your reset button may look different, but usually they are very small. Sometimes the button is under a pinhole, and you need a paper clip to push it.

Hold the reset button down for 10 seconds and watch the lights. After a few seconds the lights should blink differently. When this happens, the reset is complete. Do not be concerned about holding the reset button down too long. It will not hurt anything.

Remember, this will erase everything you have previously done to this Netcomm 3G10WVT router.

Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the Netcomm 3G10WVT

Once the reset is complete, you need to login to your router using the default IP address, username, and password. We have a 3G10WVT Login Guide with all this information ready for you.

Change Your Password

After logging in to your router for the first time, you need to change your router's password. It is a huge security risk to leave your router's password set to the factory default. Our Choosing a Strong Password guide can help you pick a strong password for your router.

Tip: A great place to write your new password down is on a piece of paper taped to the bottom of your router.

Other Netcomm 3G10WVT Guides

Here are some of our other Netcomm 3G10WVT guides that you might be interested in.

This is the reset router guide for the Netcomm 3G10WVT. We also have the following guides for the same router: