Setup Router logo in white Setup router name logo in white
Get Software

Reset the Netgear Nighthawk RAX70

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 4 minutes

In this article, you will learn how to reset your Netgear Nighthawk RAX70 back to factory settings. A router reset is very different than a router reboot. Unplugging a router from the wall reboots it. Resetting a router erases all settings from it and returns it to factory defaults.

Warning: Since this erases everything you have done to the router, there are some things you need to consider first. When you reset your router, the following will happen.

  • The router's login credentials are reset.
  • All WiFi login information and network names are reset.
  • If your router has any ISP settings they will be removed, and you will have to contact your ISP.
  • Any port forwards, firewall settings, or parental controls that you have configured will be removed.

A router reset is the last step you should take in recovering your router's password. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other Netgear Nighthawk RAX70 Guides

This is the reset router guide for the Netgear Nighthawk RAX70 v1.0.13.128. We also have the following guides for the same router:

Recover Password in Netgear Nighthawk RAX70

If you are resetting your router because you forgot your router password, then you should try running our Router Password Finder first.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Do not do a full router reset until after you have tried every other option to log in to your router.

Reset the Netgear Nighthawk RAX70

There is usually a small reset button located on either the back or the bottom of a router. A typical reset button looks like this:

Router Reset Button

Even though yours may look slightly different, you need to look for a tiny button. You may need a paper clip to push the reset button.

Watch the lights on the front of your router and hold the reset button down for about 10 seconds. The lights on the front of the router should do something different when the reset happens. Do not be concerned about holding the reset button down too long. It will not hurt anything.

Remember, this will erase everything you have previously done to this Netgear Nighthawk RAX70 router.

Only take this last step of fully resetting your router after you have exhausted all other troubleshooting options, such as running our Router Password Finder software, which can recover a lost router password for you.

Login to the Netgear Nighthawk RAX70

After you are finished resetting your router, you need to login in using the original factory username and password. Just follow our Nighthawk RAX70 Login Guide to find all of the information that you need.

Change Your Password

Be sure to change your router's default password after you get logged back in. The factory default passwords for routers are very well known. Our Choosing a Strong Password guide talks about choosing a strong password for your router.

Tip: A great place to write your new password down is on a piece of paper taped to the bottom of your router.

Other Netgear Nighthawk RAX70 Guides

This isn't our only Netgear Nighthawk RAX70 guide. We also have the following guides for this router.

This is the reset router guide for the Netgear Nighthawk RAX70 v1.0.13.128. We also have the following guides for the same router: