Setup Router logo in white Setup router name logo in white
Get Software

Reset the Pirelli VoIP AG

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 3 minutes

If you need to reset your Pirelli VoIP AG router back to factory settings, then this article shows you how. A router reset is very different than a router reboot. A reboot happens every time a router loses power. This is different from a reset because a reset completely erases all settings from the router.

Warning: Since this erases everything you have done to the router, there are some things you need to consider first. When you reset your router, the following will happen.

  • The router's login credentials are reset to factory defaults.
  • All WiFi settings are reset, including network name and password.
  • Any ISP settings saved in your router will be removed. You may have to contact your ISP.
  • All port forwards, firewall settings, and parental controls that you have configured will be removed.

A router reset should be considered the last resort when you cannot log in to your router any other way. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other Pirelli VoIP AG Guides

This is the reset router guide for the Pirelli VoIP AG v1-t AnnexA OT. We also have the following guides for the same router:

Recover Password in Pirelli VoIP AG

Before you resort to doing a full router reset, you may want to try running our Router Password Finder first.

Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

A router reset should be the last thing you try if you are unable to login.

Reset the Pirelli VoIP AG

Most of the time you can find a small reset button located on either the back or the bottom of a router. This is what a typical reset button looks like:

Router Reset Button

Even though yours may look slightly different, you need to look for a tiny button. If you find a pinhole on the back of the router then that may be the reset button. You will need a paper clip to push it.

Keep an eye on the lights on the front of your router while holding the reset button down for about 10 seconds. After a few seconds the lights should blink differently. When this happens, the reset is complete. Keep holding the button as long as you want, it will not hurt anything to hold it down too long.

Don't forget, this step will totally reset your Pirelli VoIP AG router back to factory settings.

This last step should only be taken if you have tried everything else, such as using our Router Password Finder software, which can recover lost or forgotten router passwords.

Login to the Pirelli VoIP AG

Now you need to log in using the factory default username and password. Our VoIP AG Login Guide has all of the information that you need.

Change Your Password

Do not forget to change your router's default password when you log back into it. It is a huge security risk to leave your router's password set to the factory default. Our Choosing a Strong Password guide can help you pick a strong password for your router.

Tip: Write your new password down on a post-it note and stick it to the bottom of your router.

Other Pirelli VoIP AG Guides

We have collected a lot of information about the Pirelli VoIP AG router. You can find some of our additional content here.

This is the reset router guide for the Pirelli VoIP AG v1-t AnnexA OT. We also have the following guides for the same router: