Setup Router logo in white Setup router name logo in white
Get Software

Reset the TP-Link Archer A7 v5.0

Thumbnail image of Setup Router Staff
Setup Router Staff
Last Updated: | Reading Time: 5 minutes

This is the reset guide for the TP-Link Archer A7 v5.0 router. A router reset is very different than a router reboot. Unplugging a router from the wall reboots it. However, when you reset a router you, return it back to its factory default settings.

Warning: Since this erases everything you have done to the router, there are some things you need to consider first. When you reset your router, the following will happen.

  • The router's login and password are reset to factory defaults.
  • All WiFi settings are reset, including network name and password.
  • If your router has any ISP settings they will be removed, and you will have to contact your ISP.
  • Any firewall settings, parental controls, and port forwards that you have configured will be removed.

Since a router reset is such a drastic step, it should only be done as a last resort when you cannot recover your router's password using any other methods. Make sure that you have tried to recover your router password using our Router Password Finder first.

Other TP-Link Archer A7 v5.0 Guides

This is the reset router guide for the TP-Link Archer A7 v5.0 1.0.1. We also have the following guides for the same router:

Recover Password in TP-Link Archer A7 v5.0

Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.

Router Password Finder can save you a ton of time by recovering your lost or forgotten router password instead of doing a full router reset.

Router Password Finder - Lost or Forgotten Router Password Recovery Tool

Only after you have tried to recover your missing router username and password should you perform a full router reset.

Reset the TP-Link Archer A7 v5.0

On most routers you can find a small button on the back or the bottom labeled reset. A typical reset button looks like this:

Router Reset Button

Your reset button may look different, but usually they are very small. If you find a pinhole on the back of the router then that may be the reset button. You will need a paper clip to push it.

Watch the front panel lights while you hold the reset button down for at least 10 seconds. You should notice that the blinking pattern of the lights on the front of the router changes after a few seconds. Do not be concerned about holding the reset button down too long. It will not hurt anything.

Don't forget, this step will totally reset your TP-Link Archer A7 v5.0 router back to factory settings.

Be sure to only reset your router if you have tried everything else, such as running our Router Password Finder software, which can find your lost or forgotten router password for you.

Login to the TP-Link Archer A7 v5.0

Once the reset is complete, you need to login to your router using the default IP address, username, and password. You can follow the Archer A7 v5.0 Login Guide to find everything that you need to log in.

Change Your Password

Be sure to change your router's default password after you get logged back in. The factory default passwords for routers are very well known. If you need help coming up with a strong password, check out our Choosing a Strong Password guide.

Tip: Put your new password on a post-in note and stick it to the bottom of your router.

Other TP-Link Archer A7 v5.0 Guides

We have collected a lot of information about the TP-Link Archer A7 v5.0 router. You can find some of our additional content here.

This is the reset router guide for the TP-Link Archer A7 v5.0 1.0.1. We also have the following guides for the same router: