This guide shows you how to reset your TP-Link Archer MR600 v2 router. A router reset is very different than a router reboot. Every time your router loses power it reboots. A Router Reset completely erases the router and returns it to factory settings.
Warning: Before you continue, there are a few things you need to know. The following settings in your router will be changed:
- The router's login and password are reset to factory defaults.
- All WiFi information such as network name, password, and authentication method are erased.
- Your ISP settings are reset, which means you will have to contact your ISP to get them back.
- All port forwards, firewall settings, and parental controls that you have configured will be removed.
A router reset is the last step you should take in recovering your router's password. Make sure that you have tried to recover your router password using our Router Password Finder first.
Other TP-Link Archer MR600 v2 Guides
This is the reset router guide for the TP-Link Archer MR600 v2 1.5.0 0.9.1 v0001.0. We also have the following guides for the same router:
Recover Password in TP-Link Archer MR600 v2
Instead of resetting your router back to factory settings, you may want to try running our Router Password Finder first.
Our Router Password Finder can recover your lost or forgotten router password without doing a full router reset, which can save you lots of time.
Router Password Finder - Lost or Forgotten Router Password Recovery Tool
Just keep in mind that a router reset should be done as the last resort when you are unable to login to your router.
Reset the TP-Link Archer MR600 v2
Usually there is a reset button located on the back or bottom of a router. Most reset buttons look like this:
Even though yours may look slightly different, you need to look for a tiny button. Sometimes the button is under a pinhole, and you need a paper clip to push it.
Watch the lights on the front of your router and hold the reset button down for about 10 seconds. The lights on the front of the router should do something different when the reset happens. Do not worry about holding the button down too long; this is harmless.
Remember, this will erase everything you have previously done to this TP-Link Archer MR600 v2 router.
This last step should only be taken if you have tried everything else, such as using our Router Password Finder software, which can recover lost or forgotten router passwords.
Login to the TP-Link Archer MR600 v2
Once the reset is complete, you need to login to your router using the default IP address, username, and password. You can find all of the information that you need in our Archer MR600 v2 Login Guide.
Change Your Password
Be sure to change your router's default password after you get logged back in. It is a huge security risk to leave your router's password set to the factory default. Our Choosing a Strong Password guide can help you pick a strong password for your router.
Tip: Write your new password down on a post-it note and stick it to the bottom of your router.
Other TP-Link Archer MR600 v2 Guides
If you want additional help with your TP-Link Archer MR600 v2 be sure to check out some of our other guides.
This is the reset router guide for the TP-Link Archer MR600 v2 1.5.0 0.9.1 v0001.0. We also have the following guides for the same router: