This page shows how to change the DNS settings on the ZTE MF28B Rogers router.
When you connect a router to the Internet it gets a few settings from your ISP automatically. One of the settings that the ISP sets in your router is the DNS setting. DNS stands for Domain Name System and it is used to convert Internet names into actual IP addresses. For instance, when you go to "google.com", your are really connecting to an IP address that is mapped through DNS to a number such as:
This mapping happens automatically every time you visit any page on the Internet.
Some ISPs choose to abuse the DNS system and map unknown names to servers that they control. This can be done in a way that you don't know it is happening since your router is getting its DNS settings from your ISP. For instance, if you have one of these ISPs who is hijacking your DNS, and you try to surf the web to "some-random-site.com" and "some-random-site.com" does not exist, you might get a page back from your ISP with local advertisements on it.
By changing your DNS setting in your router you will effectively change the DNS setting for every computer on your network. This is because when a device is connected to your network your router automatically hands out its own DNS settings to that device. This way you can protect your entire network from ISP hijacking with just one setting.
When you change the DNS settings in your router, you usually have to enter a Primary and a Secondary setting. The secondary is only used if the primary can not be located. Here are common settings:
If you want to use Google Public DNS, use the following settings:
If you want to use OpenDNS, use the following settings:
To get started configuring the ZTE MF28B Rogers DNS page you need to login to your router. If you are already logged in you can skip this step.
To login to the ZTE MF28B Rogers, follow our ZTE MF28B Rogers Login Guide.
If you followed our login guide above then you should see this screen.
This guide begins on the Home page of the ZTE MF28B Rogers router. First, click the link at the top of the page labeled WAN Connection. Then on the left side of the page, click APN Mode.
To set the Domain Name System settings, tick the radio dot labeled Manual DNS.
Below that, in the box labeled Primary DNS, enter the main address of the DNS server you wish to use. This address is always used first.
Next, enter the secondary DNS server in the Secondary DNS box. This acts as a backup and is only used if the first can't be accessed.
That's all there is to it, don't forget to save before you exit.
Most devices on your network will not begin using the new DNS settings until they have been rebooted. After rebooting a device you can go to it's network settings and verify that it is using the DNS servers that you specified.
Don't forget about our other ZTE MF28B Rogers info that you might be interested in.