How to change the DNS settings on a Encore ENHWI-G2 router

This page shows how to change the DNS settings on the Encore ENHWI-G2 router.

Other Encore ENHWI-G2 Guides

What is the DNS setting on a Router

When you connect a router to the Internet it gets a few settings from your ISP automatically. One of the settings that the ISP sets in your router is the DNS setting. DNS stands for Domain Name System and it is used to convert Internet names into actual IP addresses. For instance, when you go to "", your are really connecting to an IP address that is mapped through DNS to a number such as:

This mapping happens automatically every time you visit any page on the Internet.

Why Change Your Router's DNS Setting

Some ISPs choose to abuse the DNS system and map unknown names to servers that they control. This can be done in a way that you don't know it is happening since your router is getting its DNS settings from your ISP. For instance, if you have one of these ISPs who is hijacking your DNS, and you try to surf the web to "" and "" does not exist, you might get a page back from your ISP with local advertisements on it.

By changing your DNS setting in your router you will effectively change the DNS setting for every computer on your network. This is because when a device is connected to your network your router automatically hands out its own DNS settings to that device. This way you can protect your entire network from ISP hijacking with just one setting.

What Should I Change My DNS To

There are 2 really great DNS servers on the Internet that you can choose from right now: Google Public DNS and OpenDNS. If you are not sure which one to pick then just use Google Public DNS.

When you change the DNS settings in your router, you usually have to enter a Primary and a Secondary setting. The secondary is only used if the primary can not be located. Here are common settings:

If you want to use Google Public DNS, use the following settings:

If you want to use OpenDNS, use the following settings:

Login To The Encore ENHWI-G2

To get started configuring the Encore ENHWI-G2 DNS page you need to login to your router. If you are already logged in you can skip this step.

To login to the Encore ENHWI-G2, follow our Encore ENHWI-G2 Login Guide.

Change the DNS settings on a Encore ENHWI-G2

If you followed our login guide above then you should see this screen.

This guide begins on the Status page of the Encore ENHWI-G2 router. To change your DNS Server settings, click the link to the left of the screen labeled TCP/IP Settings, then WAN Interface.

Configure the DNS section of your Encore ENHWI-G2

This directs you to a page called WAN Interface Setup.

Look down this page and tick the radio button labeled Set DNS Manually, unlocking the next three boxes.

The first of these boxes is titled DNS 1. Enter the primary address of the DNS Server you have decided on. This will be the address that is accessed first.

Next is the DNS 2 box. Enter the secondary address of that DNS Server here. This address is used only rarely when the first is unable to be located.

If you have a third DNS address you would like to use then enter that address in the DNS 3 box. Feel free to leave it blank if you want. Most routers don't have a third address option because it is very probable that you will never use it.

Click the Apply Changes button and you are finished.

Possible Problems when Changing your DNS settings

Most devices on your network will not begin using the new DNS settings until they have been rebooted. After rebooting a device you can go to it's network settings and verify that it is using the DNS servers that you specified.

Other Encore ENHWI-G2 Info

Don't forget about our other Encore ENHWI-G2 info that you might be interested in.

Rachel Bauer

Written by

Rachel Bauer is an owner and primary author for She is available on Google+ and you can find more of her articles in the Networking section of our site.