Setup Router logo in white Setup router name logo in white
Get Software

How to Reset the Linksys WRT350N

Thumbnail image of Setup Router Staff
Setup Router Staff
(Last Updated: ) | Reading Time: 4 minutes

Here on this page I will be describing how to properly reset the Linksys WRT350Nv2 router back to the original factory defaults.

There is a lot of confusion between a reset and a reboot. Router manufacturers will often use the term reset to mean both a reset and a reboot. In this guide when I use the term reboot I am referring to a cycle in the power to the unit. Absolutely no settings change when a reboot is done. When I use the term reset I am referring to a full factory restore of all the settings that have ever been changed. All your personal data or settings are lost.

Warning: A reset is a big step. Do not take it lightly. I strongly recommend making a list of all the possible settings you may of changed in the past. In this list you should include:

  • The router's main username and password.
  • The WiFi network name and Internet password. (This is different than the router username and password.)
  • Is this a DSL router? If so you need to re-enter the Internet Service Provider (ISP) username and password. Call your ISP for these details.
  • What other settings have you changed in the past? Make sure to write these down as well.

Other Linksys WRT350N Guides

This is the reset router guide for the Linksys WRT350N v2. We also have the following guides for the same router:

Reset the Linksys WRT350N

The image below shows where the reset button is located on the Linksys WRT350Nv2 router.

router reset factory settings
This is the reset page from your Linksys WRT350N router.

First of all, make sure the router is plugged in and turned on. Then take a sharp object such as a straightened paperclip and press down on the reset button for about 10 seconds. This begins the reset process. If you don't hold the reset button down for long enough you end up only rebooting the router instead of resetting it like you wanted.

DO NOT: unplug or turn off the router during the reset process. Doing so can cause permanent damage to the device.

Remember this reset erases every single setting you have ever changed in the past. I strongly recommend trying other methods of troubleshooting before you decide to reset the Linksys WRT350Nv2 router.

Login to the Linksys WRT350N

Now that the Linksys WRT350Nv2 router has been reset you will need to login to it by using the default username, password, and IP address. Here at setuprouter.com we have compiled this information and included it in our Login Guide for the Linksys WRT350Nv2 router.

Tip: Defaults not working? The router might have not been properly reset. Try resetting it again but this time hold down the reset button for a little longer.

Change Your Password

After you successfully login to your router you should consider changing the password from the default. Default passwords are not very secure and they should be changed as soon as possible. If you need help making a password, visit our Choosing a Strong Password guide for some useful advice.

Tip: Avoid losing your password by writing it down on a piece of paper and attaching it to the underside of the router.

Setup WiFi on the Linksys WRT350Nv2

Finally it is time to secure your wireless network. To accomplish this you will need to configure the router's WiFi settings. Not sure how to do this? Check out our WiFi Instructions for the Linksys WRT350Nv2 router.

Linksys WRT350N Help

Be sure to check out our other Linksys WRT350N info that you might be interested in.

This is the reset router guide for the Linksys WRT350N v2. We also have the following guides for the same router: